FREEDOM Allure Decorative Screen Panels Instruction Manual
- June 16, 2024
- FREEDOM
Table of Contents
FREEDOM Allure Decorative Screen Panels Instruction Manual
Installation Instructions
For each panel installed, you will need (4) #8 1½” long stainless steel screws and screw covers (sold separately in matching colors).
-
In each corner there is an indentation showing the recommended fastener location. Using a ¼” drill bit to allow for expansion and contraction, pre-drill a hole in the center of each indentation (Fig. 1).
-
Place the panel in the desired location, mark the four corners on the mounting surface, and pre-drill using a 1 ⁄8″ bit (Fig. 2).
NOTE: Be sure to allow an 1 ⁄8″ between sheets for expansion and contraction. -
Place the screw cover over the screw shank. Line the screw up with the pre-drilled holes and secure the sheeting in place. Do not over-tighten the screw. Snap screw cover in place to hide the fastener (Fig. 3).
When cutting panel to smaller size:
- Use a carbide blade with no less than 24, but no more than 60 teeth; thin kerf
- Scrape away any plastic that built up along the edge with metal edge (e.g. a paint scraper or knife edge)
- Sand away any fibers that are left at edge if cut is still perceived as undesirable (100-200 grit paper recommended)
NOTE: All 4 corners of the panel must be fastened to the mounting surface
To obtain and review a copy of the warranty please go to:
Freedomproduct.com/warranty. You can also contact
1-888-418-4400 or write to Freedom
Outdoor Living, 7830 Freeway Circle, Middleburg Heights, Ohio 44130 to
obtain a copy of the warranty.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>