PHILIPS RC065B Ledinaire Panel Instruction Manual
- June 4, 2024
- Philips
Table of Contents
PHILIPS RC065B Ledinaire Panel
This product contains a light source of energy efficiency class. The light source and/or control gear and/or the external flexible cable contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
WHAT’S IN THE BOX
ACCESSORY
DIMENSIONS
The luminaire shall not be covered with thermal insulation or similar material under any circumstance.
IMPORTANT:
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similarly qualified person in order to avoid hazards.
- The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similarly qualified person.
- The luminaire must not be used or stored in a corrosive environments where hazardous materials such as sulfur, chlorine, phthalates, etc, are present.
Inrush current
PSD Touch & Dim
INSULATION
PSD
PSU
INSTALLATION
Disconnect before servicing
- Luminaire has basic insulation between Low Voltage supply and control conductors
- The light source contained in this luminaire and the external flexible cable shall only be replaced by the manufacturer or his service agent or a similarly qualified person.
- Storage, installation, use, operation, and maintenance of the products need to be performed exactly according to the instructions in this manual and/or other instructions as may be provided by us to guarantee safe use of the product over its entire lifetime. Failure to adhere to these instructions will invalidate your entitlement to a warranty. Bolts with an indication of torque strength on the drawing need to be tightened using a calibrated torque wrench. Pre-assembled bolts need to be retightened again to the required torque specification to assure maximum strength over a lifetime.
- SR compatibility – For SR-based luminaires, only SR-Certified components/sensors are to be used (see also: http://www.lighting.philips.co.uk/oem-emea/products/driving-connected-lighting). The functional compatibility of two (SR-certified) components/sensors to be used in combination, as well as the override possibility of any line-switch function used in an SR-based luminaire, is to be released by the master component/sensor supplier. If using a NEMA 7-pin socket on an SR-based luminaire, a full system verification is required. Not following this advice can/will cause a risk of damage and non-compliance for which Signify cannot take any responsibility
References
- Identity Digital | Create authentic digital identities with the world's largest and most relevant domain extension portfolio.
- Welcome | Philips lighting
- OEM Lighting - Connected with Quality | Philips lighting
- OEM Lighting Products - Explore The Range | Philips lighting
- Welcome | Philips lighting
- Welcome | Philips lighting
- Driving connected lighting | Philips lighting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>