KIDKEN HF-2102B Dog Dryer Instruction Manual
- June 16, 2024
- KIDKEN
Table of Contents
KIDKEN HF-2102B Dog Dryer
Product Parameters
Product Installation
- Align the hose buckle with the air outlet slot on the main unit.
- Rotate counterclockwise to install the hose.
- Align the hose buckle with the buckle slot of nozzle.
- Rotate clockwise to install the nozzle.
Nozzle Instructions for Use
Eight-finger comb nozzle
Air pressure dispersion for better drying effect
Large flat nozzle
A large and concentrated blowing area for sweeping water and drying quickly
Small curved nozzle
Strong and concentrated wind for quick drying of thick and local hairs
Round nozzle
Soft wind for styling pets’ fluffy hair
Touch Screen Instructions
- Plug in the power. The power button indicator flashes slowly, entering the standby mode. Press and hold the power button for 3 seconds to switch on/off the machine.
- Press the wind speed level “+” to start the machine. (The default mode is “F1”. “F1” is minimum, “F5” is maximum.)
- Press the temperature “+”, “-” button. The screen flashes slowly. Press to increase the temperature one degree. The highest temperature is 60 °C, the lowest temperature is 35 °C . The machine will automatically confirm the temperature 3 seconds after setting.
- Press the negative ion switch/ozone switch to start the negative ion wind/sterilization.
- After finishing your pet’s blow-dry, switch off the machine. If not in use, please unplug the power supply in time.
- Please unplug the machine if not in use.
Maintenance
- The back cover of the machine may be blocked by a large amount of pet hair or foreign objects, which will reduce the air volume, and even cause the motor overheating. Please periodically open the back cover, take out the filter cotton net, rinse it with water and dry it, and then put it in the back of the machine.
- Always keep the machine surface dry and clean. Clean it with a soft cloth or towel after use.
Cautions
- The machine should only be connected to a 240V(UK) or 115V~120V(USA) power supply.
- This product is not recommended for use in areas near water, if it is really necessary, to enhance safety, it is recommended to install a residual current device (RCD) in the bathroom’s electrical circuit with a rated residual operating current not exceeding 30mA.
- If the power cord is damaged, it must be replaced by a professional from the manufacturer or maintenance department to avoid electrical leakage.
- Do not use this product near textiles or flammable and explosive materials (such as gas storage tanks, LPG, volatile gases, paint thinners, etc.).
- Do not allow any material to clog or block air intakes, as this may cause the appliance to have a bad air inlet and result in a malfunction or electrical hazard.
- Please unplug the power immediately if the appliance is not working properly.
By following these cautions, you can ensure a safe and effective use of our pet hair dryer. If you have any questions or concerns, please contact our customer service team for assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>