ROLLER GRILL 400 FE Electric Crepe Machine Instruction Manual
- June 16, 2024
- Roller Grill
Table of Contents
*304.025 ELECTRIC CREPE MACHINE – MANUAL
Instructions for use and installation
Electric crepe machine 400 FE
Description of the appliance
The 400 FE crepe machine is prefect for a use in small area due to their
dimensions and weight.
The 400 mm diameter plate allow you to made crepes and pancakes
This appliance is for professional use and must therefore be used by qualified
personnel.
The identification plate is located on the back of the appliance.
Dimensions and capacity
| Appliance | Tension | Weight | Current input | Power |
|---|---|---|---|---|
| 400 FE | 230 V | 16 kg | 16 A | 3600 W |
| 400 FE | 110 V | 16 kg | 15 A | 1650 W |
Installation
Nota : The side panels of your appliance must not be placed next to a
wall or partition made from combustible material, otherwise, they must be
covered in an effective heat insulating material. A distance of 10cm from the
partition is deemed sufficient.
Do not install your appliance close to a source of humidity or stream.
Before effecting the connection, check your main supply and its contact rating
Connect your appliance to a socket fitted with an earth.
Operation
Your crepe machine is fitted with a regulation thermostat and a temperature
control pilot light.
Before first use, it is important to remove with a detergent the anti-rust
coating applied to the griddle in the factory.
Pre-heat your crepe machine for about 15 minutes with the thermostat on
maximum position. Once pre-heating is finished, set the thermostat to the
temperature required.
If slight traces of oxidisation appear, you can remove them with a metal
brush.
Care and maintenance
Your appliance should be cleaned regularly with a damp sponge.
Do not clean your appliance under running water. Water entering the system
might damage it.
For improved service, we advise that periodic maintenance checks are carried
out by a qualified installer.