VIETA PRO Carlota VAC010 True Wireless Earbuds User Guide

Carlota VAC010 True Wireless Earbuds

Quick Start Guide
Carlota VAC010

What’s In The Box

Charging

Power ON/OFF

Bluetooth Connection

Buttons

Tech Specs

1.2\PNP 1.3\ HID 1.0\SDP CORE4.2\L2CAP CORE 4.2
Rated Power:| 3mW
Frequency response:| 20-20K Hz
Signal-to-noise ratio:| > 60dB at 1KHz 0dB 1mW
Battery type:| Lithium-ion (3.7V,40mAh) for single earphone
Lithium-ion (3.7V, 400mAh) for charging case
Battery charge time:| 1-2 hours
Music Playtime:| 4 hours (50% volume), up to
20 hours of battery life
Dimensiones (W x D x H):| 525222mm
Weight:| 40 g.

To prolong Battery Lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions. Do not expose the Vieta Pro product to liquids without removing all cable connections and close the cap tightly. Do not expose Vieta Pro product to water while charging. It may result in permanent damage to the speaker or product, and power source.

IMPORTANT SAFETY INSTRUCTIONS:

Security
For all the products:

1. Read and follow these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not block any ventilation openings. Install this product following the nstructions.
6. Do not install this product near any heat sources such as radiators, heat registers stoves or other devices (including amplifiers) that produce heat.
7. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong I provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
8. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the device.
9. Use only attachments/accessories specified by the manufacturer.
10. Unplug this device during lighting storms or when unused for long periods of time.
11. To disconnect this device from the AC mains completely, disconnect the power-supply card plug from the AC receptacle.
12. The mains plug of the power-supply cord shall remain readily operable.
13. Do not expose batteries to excessive heat such as sunshine, fire or the like.
14. This device is intended to be used only with the power supply and/or charging cable provided by the manufacturer.

PRECAUCIÓN
RISK OF ELECTRIC SHOCK. DO NOT OPEN
The lightning flash with an arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “Dangerous Voltage” within product’s enclosure that may be of sufficient magnitude to constitute a risk of electrical shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
WARNING: To reduce the risk of fire or electric shock, do not expose this device to rain or moisture.

CAUTION FCC AND IC STATEMENT FOR USERS (USA AND CANADA ONLY).
This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions:

1. This device may not cause harmful interference.
2. this device must accept any interference received, including interference that may case undesired operation CAN ICES-3(B)/NMB-(3)B

Federal Communication Commission Interference statement. (FCC).
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful off and on, the user is encouraged to try to connect the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by Vieta Pro could void the user’s authority to operate the equipment.
For Products that transmit RF Energy:
FCC AND IC INFORMATION FOR USERS:
This device complies with Part 15 of the FCC rules and Indrustry Canada license-exempt RSS stardard(s). Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including the interference that may cause undersired operation

FCC/IC Radiation Exposure statement.
This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
For Wi-Fi 5G device. FCC Caution:
High power radars are allocated as primary user of the 5.25 to 5.35Ghz and 5.65 to 5.85GHz bands. These radars stations can cause interference with and/or damage this device. No configuration controls are provided for the wireless equipment allowing any change in the frequency of operations outside the FCC grant of authorization for US operation according to Part 15.407 of the FCC rules.
IC Caution:
User should also be advised that:

1. The device for operation in the band 5150 – 5250Mhz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.
2. The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit.
3. The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits specified for point-to-point operation as appropriate.
4. Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.

Exposure of humans to RF fields (RSS-102)
The computers employ low gain integral antennas that do not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health
Canada’s web site at http://www.hc-sc.gc.ca/
The radiated energy from the antennas connected to the wireless adapters conforms to the IC limit of the RF exposure requirement regarding IC RSS-102, Issue 5 clause 4, SAR tests are conducted using recommended operating positions accepted by the FCC/RS
with the device transmitting at its highest certified power level in all tested frequency band without distance attaching away from the body. Non-compliance with the above restrictions may result in violation of FCC RF exposure guidelines.
Use Restriction: Attention in France, operation is l mited to indoor use within the band 5150-5350MHz.
For Products with Radio Receivers That Can Use an External Antenna (USA only): CATV (Cable TV) or Antenna Grounding.
If an outside antenna or cable system is connected to this product, be certain that it’s grounded so as to provide some protection against voltage surges and static charges. Section 810 of the National Electrical Code (NEC), ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of the antenna discharge unit, connection to grounding electrodes and requirements of the grounding electrode.
Note to CATV System Installer:
This reminder is provided to call the CATV (cable TV) system installer’s attention to article 820-40 of the NEC, which provides guidelines for proper grounding system of the building, as close to the point cable entry as possible.
For CD/DVD/Blu-ray Disc ™ Players: Caution.
This product uses a laser system. To prevent direct exposure to the laser beam, do not open the cabinet enclosure or defeat any of the safety mechanisms provided for your protection. DO NOT STARE INTO THE LASER BEAM. To ensure proper use of this product, please read the owner’s manual carefully and retain it for future use. Should the unit requ re maintenance or repair, please contact your local
Vieta Pro service center. Refer servicing to qualified personnel only.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1 LASER APPARAT
CLASSE 1 PRODUIT LASER

FOR ALL EU COUNTRIES:
For products that include audio out.
Prevention of hearing loss.
Caution: Permanent hearing loss may occur if earphones or headphones are used at high volume for prolonged periods of time.
The products have been tested to comply with the sound Pressure Level requirement laid down in the applicable NF EN 50332-1:2013 and/or EN 50332-2:2013 standards as required by French article L.5232-1.
Note: To prevent possible hearing damage, do not listen at high volume levels for long periods. This product complies with the requirements of the EU (1999/5 /EC) regarding the Limiting the exposure of the general public to electromagnetic fields as regards health protection. The limits are part of broad recommendations for the protection of the general public. These recommendations have been developed and verified by scientific organizations doing specific test and evaluations of scientific studies. The measurement for the European Council recommended limit for mobile devices is the “Specific Absorption Rate” (SAR) and the average sAR limit is 2.0W/Kg on 10 grams of body tissue.
FRAMASON AUDIO S.A. it meets the requirement of the International Commission on Non-Ionizing Radiation Protection (ICNRP).
In the case of body use, this product has been tested and meets the ICNRP exposure guidelines and the European Standard EN 62479 and EN 50663. The SAR value has been measured with the device at a distance of 1.0 cm from the body transmitting at the highest certified output power level in all frequency bands of the mobile device.
Aviso de WEEE: The Directive on Wate Electrical and Electronic Equiment (WEEE), wich entered into force as European law on 14/02/2014, resulted in a major change in the treatment of electrical equipment at end-of-life. The purpose of this Directive is, as first priority, the prevention of WEEE, and in addition, to promote the reuse, recycling and other forms of recovery of such wastes so as to reduce disposal. The WEEE logo is shown on this part.
This product must not be disposed of or dumped with your other household waste. You are liable to dispose of all your electronic or electrical waste equipment by relocating over to specified collection point for recycling of such hazardous waste. Isolated collection and proper recovery of your electronic and electrical waste equipment at the time of disposal will allow us to help conserving natural resources. Moreover, proper recycling of the electronic and electrical waste equipment will ensure safety of human health and environment. For more nformation about electronic and electrical waste equipment disposal, recovery and collection points, please contact your local city center, household waste disposal service, shop from where you purchased the equipment, or manufacturer of the equipment.
RoHS Compliance.
This product is in compl ance with Directive 2011/65/EU and its amendment (EU) 2015/863 of the European Parliament and of the Council of 4 June 2015 on the restriction of the use of certain hazardous substances in electrical and electronic equipment.
For Products That Include Batteries.
EU Batteries Directive 2013/56/EU
A new battery directive 2013/56/EU on Battery and Accumulator replacing directive entered into force on the 01/07/2015.
The directive applies to all types of batteries and accumulators (AA, AAA, button cells, lead acid, rechargeable packs) including those incorporated into appliances except for military, medical and power tool applications. The directive sets out rules for collection,
treatment, recycling and disposal of batteries, and aims to prohibit certain hazardous substances and to improve environmental performance of batteries and all operations in the supply chain. Instructions for Users on Removal, Recycling and Disposal of Used Batteries.
To remove the batteries from your equipment or remote control, reverse the procedure described in the owner’s manual for inserting batteries. For products with a built-in battery that lasts for the lifetime of the product, removal may not be possible for the user. In this case, recycling or recovery centers handle the dismantling of the product and the removal of the battery. If, for any reason, it becomes necessary to replace such a battery, this procedure must be performed by authorized service centers. In the European Union and other locations, it is illegal to dispose of any battery with household trash. All batteries must be disposed of in an environmentally sound manner. Contact your local waste-mana-gement officials for information regarding the environmentally sound collection, recycling and disposal of used batteries.
WARNING: Danger of explosion if battery is incorrectly replaced. To reduce risk of fire or burns don’t disassemble, crush, puncture, short external contacts, expose to temperature above 60ºC (140ºF), or dispose of in fire or water. Replace only with specified batteries.
**** The symbol indicating “separate collection” for all batteries and accumulators shall be crossed-out wheeled bin shown here.
In case of batteries, accumulators and button cells more than 0.0005% mercury, more than 0.002% cadmium or more than 0.004% lead, shall be marked with the chemical symbol for the metal concerned; Hg, Cd or Pd respectively. Please Refer to the below symbol:

WARNING:
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD (The remote control supplied with). This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or place inside any part of the body, seek immediate
medical attention.
For All Products Except Those with Wireless Operation:
FRAMASON AUDIO S.A. hereby declares that this equipment is in compliance with the EMC 2014/30/EU Directive, LVD 2014/35/EU Directive. The declaration of conformity may be consulted on our
Web site www.vieta.es.
For All Products with Wireless Operation:
FRAMASON AUDIO S.A. hereby declares that this equipment is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted on our Web site www.vieta.es.

The Bluetooth® word mark and logo are registered trademarks owned by Bluetooth SIG, Inc.
Compatible with Android and Apple. “Android” is a trademark of Google Inc. “Apple” is a trademark of Apple Inc.
Designed and engineered in SPAIN. Made in China.
Imported and distributed in USA by BELISA LLC, 6420 Rea Road Suite A1 #252, Charlotte, NC 28277, USA.
VIETA® is a trademark of FRAMASON Audio, SA.

FRAMASON AUDIO S. A
Avd. Pau Casals Nº7 I entlo. 2 I 08021 Barcelona, Spain.
www.vietapro.com
FCC ID: 2ARR8-KTW-823
Europe: service@vieta.es
Americas: support@vietapro.com

References

• Anatel — Agência Nacional de Telecomunicações
• Welcome to the Health Canada Web site | Bienvenue au site Web de Santé Canada
• Vieta Pro
• Vieta Pro

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>