ALW-R03-23 Ally Screen Device User Manual
- June 16, 2024
- ally
Table of Contents
**ALW-R03-23 Ally Screen Device User Manual
**
To use your Ally®, once mounted, simply:
- Plug into power supply (5V/2.1A)
- Wait for AllyⓇ to start up-MPC will auto-launch
- Connect to Wi-Fi
- Adjust time zone
- Enter your personalized MPC key
- Enter Store Credentials
- Select product
Package Contents
This package contains five (5) of each:
- Ally® 4” touch screen player
- USB A to C cable
- Mounting bracket
- Mounting tape
- Mounting screw & anchor kit
Mounting
Ally® allows three (3) mounting options:
Built-in stand: Use built-in 30-degree fold-out for tabletop display.
then adhere bracket to desired location. Use clips to attach AllyⓇ to bracket.
Mounting screw & anchor kit: Use to rmly attach to surfaces where tape
may not stick well.
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Warning:
NOTE:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
Warning:
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reason- able protection against harmful interference in a
residential installation. This equipment generates, uses and can radi- ate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful inter- ference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interfer- ence
to radio or television reception, which can be deter- mined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC Radiation exposure limit set forth for uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.