WISE ALLY AP82 Rapid Response Button User Guide
- June 6, 2024
- WISE ALLY
Table of Contents
Rapid Response Button User Guide
The Rapid Response Button is designed to improve employee safety by providing indoor location information of employees upon emergency leveraging PwC’s Indoor Geolocation Platform (IGP).
-
Lanyard Ring
Attach lanyard with the ring to wear the device -
Left Button with LED
The left button is smooth and translucent with LEDs inside it -
Right Button
The right button is blue and textured
Trigger / Stop Alerts
Press and hold both the left button and the right button to trigger alerts and
location reports. The LED will flash when an alert is triggered.
Press and hold both buttons again to stop alerts.
Silent / Audible Alert Mode
When the silent alert mode is triggered, the device will vibrate once and the
LED will flash green. Once a location report is sent, the device will vibrate.
When the audible alert mode is triggered, the device will beep and the LED
will flash red. Once a location report is sent, the device will vibrate.
If an alert is triggered and not stopped, the device will send a location
report every one minute
Check Silent / Audible Alert Mode
Press and release the right button. If the LED flashes green, the device is in silent alert mode. If the LED flashes red, the device is in the audible alert mode
Switch Between Silent / Audible Alert Modes
Press and hold the right button for 3 seconds to switch between silent /
audible alert modes
The device will beep and flash the green LED when it is switched to the silent
alert mode
The device will beep and flash the red LED when it is switched to the audible
alert mode
(4) USB Port and Reset Pin
(4a) Micro USB Port for charging and device update (by device managers) (4b)
Reset pin. The device can be power cycled by pressing the reset pin with a
paperclip
(5) Recessed Area for Badge
Optionally stick an employee badge photo in the recessed area
(6) Device Label
- DevEUI: LoRa Device Extended Unique Identifier
- Address: Device MAC address
- Serial No. Device serial number
- FCC ID: Device FCC ID
- QR Code: Scanning of the QR code renders a concatenated DevEUI, Address, and Serial No.
(7) USB Charging
Cable Charging Micro USB cable for the device
Caution: The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. End-user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Device Specs:
Model: AP82
Radio Frequency Band: 900MHz
Band WiFi-Band: 2 4GHz
Bluetooth Version: 4.2
Dimensions: 2.6 x 4.5 x 0.4 inch
Weight 62g
Battery: 500mAh
Operating Temperature: 0-45C
Relative Humidity: 0-95%