BaByliss E652E-T130a Nose Trimmer Instruction Manual
- June 4, 2024
- BaByliss
Table of Contents
BaByliss E652E-T130a Nose Trimmer
PREPARATION
- Always inspect the appliance before use for noti-ceable signs of damage. Do not use if damaged as injury may occur.
- Ensure trimmer head is free from hair and debris (refer to Cleaning & Maintenance section for further information).
TO OPERATE THE DEVICE
- To insert a battery, remove the base of the device by turning it to the left so that mark (I) lines up with mark ( ). Next pull the bottom part of the device downwards (Fig. 1)
- I nsert one AA alkaline battery, positive terminal up («+»). (If you are not going to use the device for long periods, or if the battery is flat, remove the battery from the device. This will increase the trimmer’s wor-king life.).
- After inserting the battery, put the base of the de-vice firmly back in position.
- Turn the device on by turning the base of the device to the right to line up the two marks (I) (Fig. 2).
Inserting and removing the cutting heads
Turn the device to the «off» position by turning the base of the device to the
left so that mark (I) lines up with mark (0)(Fig. 3).
- Gently place the desired cutting head on the device, then lock in position by turning the cutting head to the left so that the two marks line up (I) (Fig. 4).
- Remove the cutting head of the device by turning it to the right, to line up mark (I) with mark ( ). Then pull the head of the device upwards (Fig. 5)
Using the special rotary cutting head for nose and ears
Gently insert the rotary cutting head into the nostril or ear to cut the hair.
Using the special precision cutting head for eye-brows Putting the
cutting guide in place
To put the cutting guide in place on the special pre-cision cutting head
eyebrows, first ensure the device is turned off.
- For a 3 mm cutting height, slide the cutting guide onto groove A.
- For a 5 mm cutting height, slide the cutting guide onto groove B (Fig. 6).
MAINTENANCE
- Turn the device to the «off» position (Fig. 3).
- Remove the cutting head of the device by turning it to the right to line up mark (I) with mark ( ). Next pull the head of the device upwards (Fig. 5)
- Remove any build-up of hairs on the head by blowing on them or using a small cleaning brush. You can also rinse the head of the device under running water (Fig. 7). However, the handle must not come into contact with water. Remove the cutting head of the device to rinse it under water.
- Ensure the head is completely dry before putting it back in the device and turn it to the left until the marks are lined up.
- Do not use the device in the shower or bath.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>