Vzyhik 1-Pack Solar Street Light User Manual

Vzyhik 1-Pack Solar Street Light User Manual

Warm Tips

Step1: Turn on the switch (Long Press Button)
Step2: Charging 2 hours under the sunlight
Step3: Test the remote controller work or not (Note: Remote control is pointed at the receiver)

Follow the instruction when you received

1. Block the light sensor part (solar panel) and Turn on the switch (Long Press Button).
2. Charging 2 hours under the sunlight. The indicator light flashes to indicate that it is charging, the color of the fully charged indicator light is 2 red lights + 2 blue lights + 1 green light (Indicator no longer flashes)
3. Test the remote controller work or not.
   (Note: Remote control is pointed at the receiver)

Package

①Solar light|

---|---
②Fixing arm pole|

③Back plate for pole mounting|

④ Back plate for luminaire mounting|

⑤ Remote control|

⑥ Open spanner|

⑦ Battery|

⑧ Wall mount bolts|

⑨Long bolts for pole mounting|

⑩Short bolts for luminaire mounting|

Installation

Wall Mount

On the wall
Step 1: Mark the hole location, Drill 4 holes in the wall according to the position of the bracket’s hole.
Step 2: Knock the bolts into the wall.
Step 3: Mount the light, lock the screws and tighten them.

Pole Mount

On the pole
Step1:Secure the light to the pole with the long bolt and back plate.
Step2: then tighten the long bolt .

Remote Control Buttons

Note: Please long press“（ ）”until the light turns on

Power display meaning

When fully charged, all indicator lights will be on (2 red lights+ 2 bole lights+ 1 greenlight),the color of the battery indicator will not change.

Remote Control Buttons

Please insert the 2 batteries ((1.5 V AAA type). Make sure that the positive and negative ends are facing in the correct direction. the control distance of remote is 35ft.

1. When you press the button ON, the solar street light will be 100% brightness.

2. When you press the button OFF, the solar street light will be turned off and cannot be turned on automatically until the next day. (Tips: You need to press ( )on the light body to turn off the solar street light completely.)

3. 
   Motion Sensor Mode: When motion is detected, the brightness increases to 100%. When there is no motion, it is stationary for about 10-20 seconds and the brightness returns to 30%.

4. 
   Timed Lighting: Timed 100% brightness Lighting 2/3/5/6/8 hours without radar sense motion function.

5. 
   Brightness level: you can set up the brightness level (25%/50%/75%/100%) of the light.

Motion Sensor Mode

No motion is detected, 30% Brightness

Motion is detected, 100% Brightness

30% Brightness Restored after 20 seconds after the people leave.

How does your solar powered fixture work?

1. During the day, the solar converts sunlight into electricity and recharge the battery. At night, the light turn on automatically using the electricity stored during that day.
2. The number of hours the lights depends on your geographic allocations, weather conditions and seasonal sunlight availability. Also. it depends on the lighting time you choose.
3. Place the solar light fixture in an area where it can receive direct sunlight format least 8 hours each day. Shadowed locations should not be near lights. as these may cause the solar light to turn off prematurely.

Precautions

1. First time of use, place the solar light in a location where it can receive a full8 hour of sunlight to allow the rechargeable battery to reach maximum capacity.
2. Then put the solar panel in the sun to charge Please choose a position without any shelter forenough sunshine and the solar panel should be fully exposured under sun.
3. Keep the solar panel surface clean, this helps speed up charging. It is suggestedto clean the solar panel for a period of time.
4. The light will turn off after run out of battery especially in area that lack of sunlight, in cloudy winter and during long rainy weeks. If such problem occur.first press OFF charge the solar panel for two days and then turn on .
5. Test light control: After blocked the solar panel, press the “   ” button, the light son; the solar panel is facing the sun light, the light is off, then the light control informal.

Troubleshooting

If the light does not turn on at dusk after 8 hours of charging:*Ensure that the solar light fixture is in a bright sunny location and not ina shady area during the day.

• Make sure that the solar light fixture is turned on(Auto)
• Make sure that the remote control battery has power.
• If the above faults are eliminated, it may be that the solar battery needs to be replaced or the controller is faulty. Please contact me in time.

Warranty

We provide our customers with a warranty of 12 months from the date of purchase.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>