RICE LAKE PN 219274 Load Cell Cable Connection Instruction Manual
- June 16, 2024
- RICE LAKE
Table of Contents
**RICE LAKE PN 219274 Load Cell Cable Connection Instruction Manual
**
Load Cell Cable Connection
Product: Health weigh Indicator
Issue: SAT appears on the indicator display
Cause: Improper cable connection
Solution: Connect the cable into the load cell connection port
When SAT appears on the display, the load cell cable may be plugged into the wrong connection port.
Manuals and additional resources are available from Rice Lake Weighing Systems at www.ricelake.com/manuals Warranty information is available at www.ricelake.com/warranties
Use the following steps to ensure the cable is connected to the load cell connection port:
- Remove the four screws securing the back cover to the indicator **(see Figure 1).
Figure 1. Back Cover Screw Locations**
- Connect the load cell cable to the indicator by plugging it into the load cell connection port.
- Secure the cable with the zip tie **(see Figure 2).
Figure 2. Indicator to Load Cell Cable Connection
IMPORTANT:** Do not plug the load cell cable into the RS-232 connection
port on the right side
- Ensure the cable routes through the notch in the top of the back cover **(see Figure 3).
Figure 3. Cable Through Back Cover Notch**
- Reinstall the back cover of the indicator.
© Rice Lake Weighing Systems Content subject to change without notice.
230 W. Coleman St. • Rice Lake, WI 54868 • USA USA: 800-472-6703 • International: +1-715-234-9171
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>