NiLIGHT TR-114-A 3PCS 60 Inch Truck Bed Light Strip Bundle Installation Guide
- June 15, 2024
- Nilight
Table of Contents
NiLIGHT TR-114-A 3PCS 60 Inch Truck Bed Light Strip Bundle
Product Information
Specifications
- Mounting: Tailgate
- Wire Bundle Placement: Driver side or passenger side
- Connector Type: Standard flat 4-pin
- Power Source: 12V DC positive
Product Usage Instructions
-
Wire Bundle Placement
Before installation, determine whether the wire bundle needs to be placed towards the driver’s side or passenger side. This can be tested by checking if the signal lights work properly in either direction. -
Mounting Surface Preparation
Clean and dry the mounting surface thoroughly before proceeding with the installation. Ensure that there is no dirt, dust, or moisture on the surface. -
Adhesive Tape Removal
Peel off the adhesive tape at the back of the light bar after the mounting surface has been cleaned and dried. -
Mounting the Light Bar
Based on the desired wire bundle placement, stick the light bar to the recessed area between the bottom of the tailgate and the bumper shelf. Ensure proper alignment and firm adhesion. -
Electrical Hook-up
Using the provided standard flat 4-pin connectors, plug and play the connectors into their corresponding ports. Connect the reverse wire to a 12V DC positive power source. -
Additional Hardware (Optional)
If desired, you can use the additional mount and screws provided to further secure the light bar in place. This is recommended for added stability and durability.
Frequently Asked Questions (FAQ)
-
Q: Can the wire bundle be placed on either side?
A: Yes, the wire bundle can be placed towards the driver’s side or passenger side, depending on your preference and the compatibility with your vehicle’s wiring system. -
Q: Can I install the light bar without using the adhesive tape?
A: It is recommended to use the adhesive tape provided for proper installation and secure attachment. However, if you prefer an alternative mounting method, you may explore other options such as brackets or clamps, ensuring they are compatible with the light bar.
Installation Instaruction
Firstly be sure to decide whether the wire bundle needs to be towards the driver’s side or passenger side by testing when signal lights work properly.
Peel
After cleaning and dry the mounting surface. Peel off the adhesive tape at the
back.
Stick
According to the mounting direction of the wire bundle, stick the light bar to
the recessed area between the bottom of the tailgate and the bumper shelf.
Electrical Hook-up
Plug and play the standard flat 4-pin connectors, and connect the reverse wire
to a 12V DC positive power source.
Additional Hardware
You can also add on an additional mount and screws we provide to secure the
light bar.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>