Pass Seymour CR6360 50A Plugs And Connector Instruction Manual

Pass Seymour CR6360 50A Plugs And Connector Instruction Manual

Installation Instruction

WARNING: To prevent electrocution make sure the cable is not connected to a power source before installing the plug or connector. Failure to comply with the following instructions could cause an electrical failure or fire.

1. Check to see that the rating on the plug or connector is correct for the installation.

2. Select a cable of suitable ampacity, service, arid temperature rating. The plugs and connectors are designed for use with round jacketed, hard usage cable (S-type), with a diameter from .65 to 1.20 inches, (10-4 AWG). Three-wire devices require a three conductor cable, and four-wire devices require a four conductor cable.

3. Remove the housing by loosening the two screws on the face of the device, and slide it over the cable. If a weather resistant boot is used, slide this over the cable before the housing. Strip the cable as shown below. Make sure the wire is clean and a bright copper color. If necessary, cut back the wire until clean wire is uncovered. Do not solder the ends of the wires.
   

4. Insert all the wires into the proper terminal pockets. The green wire must go into the green colored terminal (also marked “G”). The white wire must go into the white colored terminal (also marked “W”) on those devices where there is a white terminal. The black and red (on 4-wire cables) wires can go into the terminals marked “X,” “Y,” or “Z.”
   Gn 4-wire devices rated 125/250 volt, note the green and white terminals are next to each other. It may be necessary to cross the green wire with either the black or the red wire.

5. Tighten the terminal screws to 25 in-lbs torque. Make certain there is no wire insulation clamped inside any terminal and there are no stray wire strands outside the terminals.

6. Tighten the strain relief screws so the strain relief securely grips the cable jacket.

7. Slide the housing over the plug or connector body and tighten the two assembly screws.
   Note: A keyway in the housing and body property aligns the two parts.
   a. If a weather resistant boot is used, slide that over the complete assembly.

WIRING 125/250 VOLT DEVICES

See reverse side for complete wiring instructions –

1. Strip the jacket from the proper end of the cable.

   • Cable end for PLUG:
     

   • **Cable end for CONNECTOR:

**

2. Insert the black and green wires into the “Y” and “G” terminals, and tighten the two terminal screws.
   NOTE: The drawing shows the plug. The “Y” terminal is on the other side on the connector.
   

3. Twist the caule as shown and insert the red and white wires into the “X” and “W” terminals.
   

4. Tighten all the terminal screws to 25 in-lb torque.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>