GOOVER V1.2022.08 LED Strip Light Warm White COB Kit User Guide
- June 15, 2024
- GOOVER
Table of Contents
GOOVER V1.2022.08 LED Strip Light Warm White COB Kit
SAFETY INFORMATION
- DANGER: Risk of eye damage. Do not stare directly at the LED chips of this LED strip.
- CAUTION: Do not power LED tape while coiled on the reel.
- IMPORTANT: Always observe polarity for 12-volt connections, positive (+) to positive and negative (–) to negative.
- IMPORTANT: Do not install Class 2 low voltage wiring in the same runs as AC main power. If AC and low-voltage wires cross, keep them at 90-degree angles.
- Use only insulated staples, plastic ties, or wire support clips to secure cords and wires.
- Use only the output DC 12-volt LED lighting power supply that has been provided with this kit.
- Do not bend, crush or pull the cable. Protect from sharp edges, oil and heat.
- Ensure the connectors are securely fastened before operating the tape.
- Electrical waste should not be disposed of with household waste.
- Please recycle where facilities exist
WHAT YOU GET
QUICK CONNECTION
RECEIVER
When the human touches the touch tablet, and then releases within 0.5S, the switch status changes (ON / OFF). When the human touches the touch tablet over 0.5 S, the switch will turn to adjustment status (high – low – high).
INSTALLATION
Cutting the tape light (optional)
IMPORTANT
Make sure to observe polarity when making connections, positive to positive
and negative to negative. Check to see that the wire colours and the polarity
markings printed on the tape line up.
- Clean the surface where you intend to install the GOOVER LED Strips.
- Remove the backing from the light strip to reveal adhesive tape.
- Press down and run the strip in a straight line onto the surface.
- Use mounting clips if needed to make power source wire and strips stable.
TROUBLESHOOTING
Lights not turning on?
Confirm the strip is connected to the power source. (GOOVER LED strips require a 12V DC power source.) If the lights are connected to a controller, ensure they are switched on.
Lights not lighting up?
Check the voltage on your power source. Anything below the required voltage (12V DC) may result in no lighting up.
Adhesive tape not sticking?
Make sure to clean your mounting surface. Mounting tape may not work on certain surfaces such as wood, stone and other rough materials. Try GOOVER Foam Tape, Mounting Clips, or an adhesive suited to the material in question.
WARNING! DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!
Read all warnings and installation instructions thoroughly.
HANDLE LED TAPE LIGHT WITH CARE!
Have any questions, please contact us!
service@gooverlight.com