RainPoint IK15P Drip Irrigation System With Solar Pump Timer User Manual

June 15, 2024
RainPoint

RainPoint IK15P Drip Irrigation System With Solar Pump Timer

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
PRODUCT

WHAT IN THE BOX

Rainpoint Outdoor Irrigation Pump x 1

5W Solar Panel x 1| Cross Connector x 3
Solar Panel Bracket x 1| Sealing End x 3
15m (50ft) 1/4″ Pipe x 1| Filter x 1
Micro Dripper x 15| Anti-backflow Valve x 1
T-barb Connector x 15| Type-C Charging Cable x 1
Straight Connector x 5| Low Water Level Detector x 1

OVERVIEW

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-1

BUTTON FUNCTION INTRODUCTION

Dial Functions

ON| Run the timer as scheduled
OFF| Turn off the timer
SET CLOCK| Set current time
START TIME| Set the time to start watering
HOW LONG| Set the duration of the watering plan
HOW OFTEN| Set the frequency of the watering plan

Button Functions

OK/MANUAL BUTTON| Confirm settings or water manually
+/DEALY BUTTON| Adjust settings or set delay watering
– BUTTON| Adjust settings

SPECIFICATION

  • Flow rate 45UH (11.9 Gal/min)
  • Watering duration from 30 sec to 30 mins
  • Working temperature from 0°C to 50°C (37°F to 122ºF)
  • Powered by 1 * 18650 Lithium Ion Rechargeable
  • Battery (2600mAh)
  • IPX4 water proof

INSTALLATION

  1. Install the pump in the proper place. There is a back holder that can help fix it.
  2. Find a shadow-free place to place the solar panel using the U-stand. Or Screw the bracket on the solar panel U-stand and insert the product into the soil. Connect the solar panel cable to the solar port of the pump.
  3. Cut a proper long piece of pipe and connect it with the inlet port. Put the filter onto the other end of the pipe.
  4. Connect the water level detector to the port on the pump, then tie the other end of the detector together with the filter. Throw them into the water container.
  5. Cut the pipe into pieces and use the connectors to connect each piece of pipe and the dripper to build the irrigation pipeline system.RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-FIG-4
  6. Cut one piece of pipe and install the anti-backflow valve to start the end of the irrigation system to avoid backflow. After finishing an installation, connect the irrigation system with the outlet port on the pump.

Note

  • Please make sure the position of the whole watering system is higher than the maximum water level of the water container.
  • Please make sure the water level detector is tied higher than the filter, and both are vertically downward.
  • Please place the solar panel in a shadow-free place to get full sunshine.

FUNCTIONS

SET CLOCK

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-5

  1. Turn the dial to SET CLOCK.
  2. Press the + and – buttons to switch 12/24H, and press OK to confirm.
  3. Use the + and – buttons to set the current time, and hold the buttons for 3 seconds to quickly adjust.
  4. Use the OK button to switch the hour, minute, 12/24 hours.
  5. After setting, turn the dial to the next step to directly save settings.

START TIME

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-6

  1. Turn the dial to START TIME.
  2. Use the + and – buttons to set the time you want to start watering, press and hold the + and – buttons for 3 seconds to quickly increase or decrease the time.
  3. Use the OK button to switch between hours and minutes.
  4. After setting, turn the dial to the next step to directly save settings.

HOW LONG

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-7

  1. Turn the dial to HOW LONG.
  2. Press and – button to set the watering duration.
  3. Turn the dial to the next step to directly save settings.

HOW OFTEN

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-9

  1. Turn the dial to HOW OFTEN.
  2. Press the +and – button to set the watering frequency.
  3. Turn the dial to ON to activate the schedule.

MORE FUNCTIONS

Manual Watering Mode

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-10

When the dial stays in ON, press and hold the OK button for 3 seconds to enter manual watering mode. Setup the watering duration with the + and – buttons and press the OK button to start manual irrigation. Press and hold the OK button again or turn the dial to any position to stop manual irrigation.
Tips: When setting the time, if there is no action within 3 seconds, it will automatically exit the manual mode.

Delay Mode

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-11

When the dial stays in ON, press and hold the + button for 3 seconds to enter the delay mode setting. Press the + and – buttons to set the delay time for 24, 48, or 72 hours, and press the OK button to confirm. Select OH will cancel the delay mode. If there is no action within 5 seconds, then it will cancel the delay mode as well.
During the delay mode opening, hold the + button to cancel the delay.
Tips: When setting the time, if there is no action within 3 seconds, it will automatically exit the manual mode.

Low battery alert

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-12

  • When the battery symbol flashes, the pump will not open.

Water shortage alarm

  • When the product is running, if the detector detects a water shortage, the product indicator lights up red.

Solar charging prompt

  • When the solar panel is powering the pump, the indicator lights up green.

TROUBLESHOOTING

Problem Possible Factors Solution may help
Condensation on the screen Air condenses inside the screen due to the

difference in Tempe

-mature between inside and outside.

| The fog will disappear as the temperature rises, or leave it stand for a while.

WARNINGS

  1. Intended for outdoor use only, putting in the sheltered outdoors will prolong the product’s lifetime.
  2. When the power is low, please replace the batteries in time to avoid the interruption of normal operation; when replacing the batteries, please make sure that the battery compartment is dry.
  3. Do not use the timer if it’s more than 122°F(S0°C) or less than 37.4°F(3°C).
  4. Do not subject the product to extreme force and shock.
  5. Severe electrical shock could result if water is sprayed into outlets or sources of electrical current. Never immerse the product in water.

WARRANTY

Rainpoint provides a 1-year worry-free warranty against many -factoring defects in materials and workmanship from the date of purchase. During the warranty period, we’ll replace free of charge the product found to be defective under reasonable use and service as determined solely by RainPoint. To place a warranty request, please email your order ID to XXXXXXXXXXX and we’ll respond within 24 hours.

CUSTOMER SERVICE

  • Still have trouble with setup, please search for “RainPoint” on YouTube for installation videos!
  • If the user manual doesn’t have what you’re looking for or you need some help, please prepare the LOT NO. of your device and contact us before returning the product to the store.

RainPoint-IK15P-Drip-Irrigation-System-With-Solar-Pump-Timer-
FIG-15

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals