Nilight ZH408 52 Inch 783W Curved Triple Row Flood Spot Combo Beam LED Bar Instructions
- June 15, 2024
- Nilight
Table of Contents
ZH408 52 Inch 783W Curved Triple Row Flood Spot Combo Beam LED Bar
Instructions
Installation:
- Connect light bar wires to wiring harness terminals respectively, black to black, red to red.
- Run rocker switch wires through switch cutout/opening in the dash. Connect the 5-pin rocker switch with wiring harness. 2 methods of connection, please refer to the instruction on the below page.
- Connect wiring harness to the car battery. Red wire (+) with fuse to positive, black wire(-) to negative
- Turn on the power and press switch on/off to test the light.
Caution:
- The operating voltage is 12V DC. 16AWG: Max. Wattage 180W/ 14AWG: Max. Wattage 300W /12AWG: Max. Wattage 450W
- Please make sure all the exposed wires were securely wrapped by electrical insulating tape to prevent short circuit.
- Please strictly follow the instructions to avoid any hazards. If you do not feel comfortable with the installation we recommend having a professional to install or install under his guidance.
Last Step:
Complete the 5-Pin Rocker Switch Connection
Note: The above 5-Pin rocker switch connection is not completed yet,
please select either one of the following methods to complete:
Wiring Method: A
Connect red jumper wire from 2 to 6 (Lower indicator light will turn on
when the key is turned on) ** Tope this unused end
PIN-TAB OUTS:
**
- 8- Upper Light Neg. ()
- 2- Incoming from power source
- 3- Outgoing to relay, accessory or equipment
- 7-Lower Light Neg. (-)
- 6-Lower Light Pos. (+)
Wiring Method : B
Connect white jumper wire from 3 to 6 (Lower indicator light will turn on only
when the switch is turned to the on position) ** Tope this nosed end
Important
Tape ends of any unused wire connections to ensure no shorts occur. If you’re
having an issue with the product or need technical support, Ni light team is
always here to help and make sure your 100% satisfaction.
Need Help?**
Scan QR code to contact us nilight.com/pages/contact