Sunbeam GCSBCL-417-000 Steam Iron Instruction Manual

Sunbeam GCSBCL-417-000 Steam Iron Instruction Manual

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety instructions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THE STEAM IRON

1. READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
2. Use appliance only for its intended use.
3. To reduce the risk of electric shock, do not immerse the appliance in water or other liquids.
4. Always turn the appliance to “Off” before plugging or unplugging the appliance from the electrical outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
5. Do not allow cord to touch hot surfaces. Let appliance cool completely before putting away. Loop cord loosely around appliance when storing.
6. Make sure unit is off, unplugged and allow it to cool completely before filling or cleaning.
7. Always disconnect appliance from electrical outlet when filling with water or emptying, and when not in use.
8. Do not operate appliance with a damaged cord, or if the appliance has been dropped or damaged. To reduce the risk of electric shock, do not disassemble or attempt to repair the appliance, take it to a qualified service center for examination and repair. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the appliance is used.
9. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
10. Children should be supervised to ensure that they do not play with the appliance.
11. Burns could occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam appliance upside down – there may be hot water in the reservoir.
12. To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by holding it away from body and operating steam button.
13. To reduce the likelihood of circuit overload, do not operate another high wattage appliance from the same outlet.
14. If an extension cord is absolutely necessary, a cord with an ampere rating equal to or greater than the maximum rating of the iron shall be used. A cord rated for less amperage can result in a risk of fire or electric shock due to overheating. Care shall be taken to arrange the cord so that it cannot be pulled or be tripped over.
15. When filling the water tank, watch for water that can drip onto the floor and cause you to slip and fall.
16. Appliance may cause personal injury or be damaged if dropped.
17. The use of attachments not recommended or sold by the appliance manufacturer may cause injuries or void your warranty.
18. To avoid personal injury and damage to the appliance, only add water to the water tank. NEVER add cleaning solutions, perfumes, oils or any other chemical additives.
19. Care should be taken when using the appliance due to the emission of steam.
20. Do not set the iron on an unprotected surface, even if it is on the heel rest.
21. The iron must not be left unattended while it is connected to the supply mains.
22. The plug must be removed from the socket-outlet before the water reservoir is filled with water.
23. The filling aperture must not be opened during use. Instructions for the safe refilling of the water reservoir must be followed.
24. The iron must be used and rested on a stable surface.
25. When placing the iron on its stand, ensure that the surface on which the stand is placed is stable.
26. The iron is not to be used if it has been dropped, if there are visible signs of damage or if it is leaking.
27. If the iron is not operating normally, disconnect from power supply and have the iron serviced by an authorized service center.

DESCRIPTION OF THE APPLIANCE

1. Soleplate
2. Spray nozzle
3. Water reservoir Lid
4. Steam select Lever
5. Shot of steam button
6. 360º Swivel cord
7. Handle
8. Wide heel rest
9. ON/OFF Indicator Light
10. Spray trigger
11. Temperature Control Dial
12. See- Trough Water Reservoir

BEFORE FIRST USE

• When using the Iron for the first time, test it on a piece of old cloth to be sure that the Soleplate and the Water reservoir are clean.
• It is possible that the Iron will discharge some smoke or give off a slight odor during it is first usage. This is due to the initial heating of the materials used. This is completely normal and will stop shortly afterwards.
• When not ironing, always have the Steam Select Switch turned to the close position .

INSTRUCTIONS FOR USE

CHOOSING THE RIGHT WATER

• This Steam iron may be used by normal tap water. However, if the water if the region in which you live is especially hard, it is recommended to use distilled water to prolong the life of your iron.
• Do not use water that has been desalinated with chemicals.

INSTRUCTIONS FOR USE

1. Turn off the Iron and disconnect the plug from the electrical wall outlet before filling the Iron with water.
2. Turn the Steam Select Switch to the closed position.
3. Set the Iron in the position indicated below (figure 2) and fill it with water, no higher than the Max fill level shown on the See-Through Water Window.

DRY IRONING

1. Insert the plug in the electrical wall socket.
2. Make sure that the Steam Select Switch is in the closed position .
3. After the Indicator Light goes off, you may start to iron.

STEAM IRONING

Steam ironing is only possible at high temperatures (silk, wool, cotton, linen), as indicated on the Temperature Control Dial (figure 3)

1. Be sure that there is enough water in the Reservoir.
2. Set the iron in an upright position.
3. Plug the steam Iron into the wall electrical outlet.
4. Turn the Temperature Control Dial to the desired position within the range of temperatures included in the steam area of the dial.
5. Wait until the Indicator Light has turned off after lighting up.
6. Set the Steam Select Switch to the desired steam level position. You are now ready to start steam ironing. The steam will be released evenly through vents located in the soleplate for easier ironing.

SPRAY MIST

The Spray Mist feature is a powerful water spray mist that dampens the fabric to help remove wrinkles from heavy fabrics and to set creases.

1. Press the Spray Mist button firmly to start the spray

SHOT OF STEAM

The Shot of Steam feature provides an extra burst of steam for deep penetration of stubborn wrinkles. The Shot of Steam feature can be used with dry or steam ironing provided it has at least a ¼ tank of water and the Temperature Control Dial is set within the steam band.

1. Allow the iron to heat for approximately two minutes.
2. Press the Shot of Steam Button several times to prime the pump.
3. Press the Shot of Steam Button another three to four times in order to clean the unit.
4. The Shot of Steam feature is now ready for use. The Shot of Steam feature can be used continuously with just a short pause between shots. The Shot of Steam feature is most effective with the Iron held in a horizontal position on the fabric being ironed.
5. If the Water Reservoir runs dry, unplug the Iron and refill with water. The Iron may be filled with water while it is hot. Note: It may be necessary to re-prime the pump before using the Shot of Steam feature again.

VERTICAL SHOT OF STEAM

The vertical shot steam feature allows your iron to function as a garment steamer.
Tip : When using the vertical shot of steam on clothing, hang the clothing on clothes hanger for best results. Hanging curtains and drapes may also be steamed.

HOW TO USE VERTICAL STEAM

1. Allow iron to warm up.
2. Hold the iron in a vertical position, with the iron close to but not touching the fabric you want to steam.
3. With your other hand, pull the fabric tight.
4. Press the Shot of Steam button in approximately 3-second intervals as you move the iron across the wrinkled area.

WARNING : To prevent the risk of burns, keep your hand away from the area being steamed.
WARNING : DO NOT steam garments while wearing them; this may result in injuries.

IRONING TEMPERATURE

• Check the ironing instructions on the label of the items that you wish to iron. Check the temperature setting table for further instructions.
• Should the specific itoning instructions not appear on the label, follow instructions on the temperature setting table. This table is only for fabrics indicated and does not apply to special textiles with a gloss finish, etc. Textiles with special coatings (such as gloss, relief wrinkles, etc.) are best ironed at very low temperatures. If the textile consists of several different type of fibers, always select the lowest temperature, i.e the temperature recommended for the most delicate fiber in the composition (for example, if the composition consists of 60% polyester and 40% cotton, you should iron at the temperature indicated for polyester).

SETTING THE TEMPERATURE

1. Set the iron in on upright position.
2.  Connect the Iron to an electrical wall socket.
3. Set the Temperature Control dial (Figure 4) to the correct ironing temperature as indicated on the lable or the temperature settings table.

TEMPERATURE SETTINGS TABLE

Acetate, Rayon , viscose, polyester, cupro, moda
| STEAM| silk wool cotton Linen| silk wool cotton Linen
| On the label means: This article cannot be ironed (e.g. chlorofiber, elastodiene)

ANTI-CALC

The Anti Calc feature helps prevent the build up of mineral deposits in your iron.
This prolongs its life and improves the iron’s performance.

MAINTENANCE AND CLEANING

Before cleaning the Iron, always make sure that it is disconnected from the electrical wall socket and is completely cool.

SOLEPLATE

• Residue on the Soleplate can be wiped off with a cloth soaked in a solution of water and vinegar.
• Do not use scouring pads, abrasives or chemical cleaning solvents as they may damage the finish.

HOUSING

• The housing can be cleaned with a moist cloth and then wiped dry.
• Other than the recommended cleaning, no further user maintenance should be necessary. If for any reason your Steam Iron should require repairs, do not try to fix it yourself. Send it to an Authorized Service Center (please refer to the warranty included in the box).

STORING THE IRON

1. Turn off the iron and disconnect the plug from the electrical wall socket.
2. Set the Iron in an upright position and let it cool down completely.
3. Set the Steam Select Switch to the closed position .
4. Empty out all the water remaining in the Water Reservoir by opening the Water Reservoir Lid and inverting the Iron over the sink.
5. The Power Cord can be wound around the Heel Rest for easier and tidy storing once the unit has cooled down. The Iron should always be stored in an upright position.

Year Limited Warranty
Sunbeam Products, Inc. warrants that for a period of 3 years from the date of purchase, this product will be free from defects in material and workmanship. Sunbeam, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. Sunbeam dealers, service centers, or retail stores selling Sunbeam products do not have the right to alter, modify or any way change the terms and conditions of this warranty.
This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than Sunbeam or an authorized Sunbeam service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes.

What are the limits on Sunbeam’s Liability?
Sunbeam shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty.
Sunbeam disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.
Sunbeam shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claimbrought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction.

For product questions:
Sunbeam Consumer Service USA : 1-800-458-8407 www.sunbeam.com">800-458-8407 www.sunbeam.com © 2020 Sunbeam Products, Inc. All rights reserved. Imported and distributed by Sunbeam Products, Inc. Boca Raton, Florida 33431. Printed in China. Para pregnant sober los products llame: Sunbeam Consumer Service EE.UU.: 1-800-458-8407 www.sunbeam.com">800-458-8407 www.sunbeam.com © 2020 Sunbeam Products, Inc. Tod’s los derechos reservations. Distributor por Sunbeam Products, Inc. Boca Raton, Florida 33431. Impress en China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>