PPF900Z2 PUR Water Pitcher and Dispenser Replacement Filter 2 Pack Instruction Manual
- June 15, 2024
- PUR
Table of Contents
PPF900Z2 PUR Water Pitcher and Dispenser Replacement Filter 2 Pack
Install or Replace a Filter
Faucet Systems
To install or replace the filter in your faucet system, remove the device from your faucet by unscrewing the threaded mounting nut.
- Twist the back cover off
- Insert filter into the device (Don’t worry, the filter will fit loosely)
- Replace cover
Before first use, run cold water for 5 minutes in a filtered position. During filter flush, it is normal to see cloudy water and hear the sound of water pushing air out of the filter cartridge. Flushing removes any loose materials, which is normal. Before each use, run cold water for 5 seconds in a filtered position to activate the filter. Change your filter every three months for the best performance.
Pitchers & Dispensers
- To set install or replace a filter in your pitcher or dispenser, follow these simple steps or watch our video.
- If you have a PUR Plus filter, soak the filter in cold water for 15 minutes. Then hold the filter under cold running tap water for 10 seconds. Allow excess to drain.
- If you have a PUR basic filter, rinse the filter under cold water for 15 seconds.
- Insert the filter into the tray. Push down and twist clockwise to lock. If you have done this before putting the tray in the pitcher, you can firmly hit the bottom of the filter to ensure it is in place.
- Change your filter every 2 months for the best performance.
Can I run hot water through the filter?
Never run hot water through the filter. Do not use water above 100˚F/38˚C as
this may alter the filter. Use cold water only.
How do I know when to replace the filter?
Faucet Systems
To ensure maximum contaminant reduction, replace your PUR filter after 100 gallons of use or every 3 months.* If your Filter Change Light flashes red, it’s time for a new filter.
Pitchers & Dispensers
After 2 months or when the red light on your Filter Change Light Monitor is flashing, it is time to replace your filter. The 3-pack provides 6 months of clean water. 1 filter provides up to 40 gallons, or 2 months, of clean water. For best performance, change your filter every 2 months.
-
Should I soak the filter before use?
Yes, if there is some water in the pour tray, but not full, you can pour water out of the pitcher without spilling. We recommend not to pour water if the pour tray is full or close to full. -
How do I recycle my used PUR filters?
We are currently working on implementing a recycling program for our PUR customers. Please continue to check this section as we’ll provide an update once details become available.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>