PUR DS1810 Large Filtered Water Dispenser User Guide
- June 12, 2024
- PUR
Table of Contents
PUR DS1810 Large Filtered Water Dispenser
Product Information
- Model: DS1810X1
- Color Options: Z, W, B
- Filter Compatibility: PUR PLUS CRF-950Z (Included with system), PUR PPF900ZTM (Certified with system, sold separately)
- Filter Lifespan: Up to 2 months
- Certifications: Tested and Certified by WQA against NSF/ANSI Standards 42, 53, and 401
Product Usage Instructions
- Remove the spigot with the horseshoe-shaped tool from the underside of the tank if dishwashing.
- Soak the filter for 15 seconds.
- Rinse the filter for 10 seconds.
- Hold the reset button for 10 seconds until it blinks green.
- Install the filter and twist it to lock into place.
- Fill the reservoir with cool tap water.
- Enjoy purified water!
- The filter light will flash green with every pour.
- Replace the filter when the light flashes red.
- Reset the system after every 10 filter changes.
Note: The PUR Dispenser is not intended to purify water. Do not use it
with water that is microbiological unsafe or of unknown quality without
adequate disinfection before or after the system. PUR does not filter
microbes.
For more information on warranty, filters, and assistance, visit
PUR.com or call 1-800-PUR-LINE
(800-787-5463).
To access the performance data sheet and filter replacement information, visit
PUR.com/PDS.
NSF/ANSI Standard 401: This standard covers
incidental contaminants/emerging compounds found in trace levels in drinking
water supplies. While occurring at low levels, these compounds can impact the
public’s perception of drinking water quality.
Product Information last updated: 20JAN23
Part Number: A008508R0
Quick Start Guide
Model DS1810X1 | 1X= color: Z, W, B
- Remove spigot with horseshoe shape tool from underside of tank if dishwashing.
- Soak filter for 15 minutes, then rinse for 10 seconds.
- Install filter then twist and lock to align.
- Hold reset button for 10 seconds until it blinks green.
- Fill reservoir with cool tap water and enjoy!
INSTRUCTIONS
Filter will last up to 2 months.
This PUR Dispenser is not intended to purify water.
Do Not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system. PUR does not filter
microbes.
Filter Capacity:
- 40 gallons (151 liters), up to 2 months
- Max Water Temp: 82°F (28°C)
- Min Water Temp: 34°F (2°C)
Independently Certified
- System Tested and Certified by WQA against NSF/ANSI Standards 42, 53 and 401 for the reduction of the claims specified on the Performance Data Sheet.
- System Tested and Certified by NSF International against NSF/ANSI Standards 42, 53 and 401 for the reduction of the claims specified on the Performance Data Sheet.
- Effective water filter that does not remove fluoride from water
Visit PUR.com/PDS for performance data sheet and filter replacement information. NSF/ANSI Standard 401 has been deemed as “incidental contaminants/emerging compounds.” Incidental contaminants are those compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance/perception of drinking water quality.
For detailed instructions PUR.com/Support
For Warranty, Filters, Help & More: PUR.com | 1-800-PUR-LINE
(800-787-5463)
© 2023 All rights reserved.
Distributed by Kaz USA, Inc.,
a Helen of Troy Company,
400 Donald Lynch Blvd, Marlborough, MA 01752. PUR® is a trademark of Helen of
Troy Limited.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>