PUR PLUS PPT710 Series 7 Cup Pitcher User Guide
- June 12, 2024
- PUR PLUS
Table of Contents
PUR PLUS PPT710 Series 7 Cup Pitcher
Product Information
The product is a PUR Pitcher water filtration system available in different models: PPT710X1, PPT110X1, CR1110X1. Each model is available in different colors: C (black), Z (white), W (blue), B (magenta), M (silver).
The system includes a filter light located on the underside of the lid to indicate when the filter needs to be replaced. The system comes with a PUR PLUS CRF-950Z filter, which is included with the purchase. An additional compatible filter, PUR PPF900ZTM, is sold separately and is certified to work with the system.
The filter needs to be soaked for 15 minutes and rinsed for 10 seconds before installation. The filter should be installed by twisting and locking it into place. To reset the filter light after a filter change, the reset button should be held for 10 seconds until it blinks green. The filter light will flash green with every pour and will flash red when it’s time to replace the filter. The filter is designed to last up to 2 months.
It is important to note that the PUR Pitcher is not intended to
purify water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system. The
system does not filter microbes.
The product is independently tested and certified by the Water Quality Association (WQA) and NSF International against NSF/ANSI Standards 42, 53, and 401 for the reduction of specific claims mentioned in the Performance Data Sheet. The product is effective in filtering water but does not remove fluoride.
USING INSTRUCTION
- Soak filter for 15 minutes, then rinse for 10 seconds.
- Remove filter light from underside of lid before washing.
- Install filter then twist and lock to align.
- Hold reset button for 10 seconds until it blinks green.
- Fill reservoir with cool tap water and enjoy
- Filter Light flashes green with every pour.
- Replace filter when light flashes red.
- Reset after every filter change
- Filter will last up to 2 months.
This PUR Pitcher is not intended to purify water. Do Not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. PUR does not filter microbes.
PUR Replacement Filters
- PUR PLUS
- CRF-950Z (Included with system.)
- PUR PPF900Z™ (Certified with system, sold separately.)
- Filter Capacity: 40 gallons (151 liters), up to 2 months
- Max Water Temp: 82°F (28°C)
- Min Water Temp: 34°F (2°C)
Independently Certified
- System Tested and Certified by WQA against NSF/ANSI Standards 42, 53 and 401 for the reduction of the claims specified on the Performance Data Sheet.
- System Tested and Certified by NSF International against NSF/ANSI Standards 42, 53 and 401 for the reduction of the claims specified on the Performance Data Sheet.
- Effective water filter that does not remove fluoride from water
Visit PUR.com/PDS for performance data sheet and filter replacement information.
NSF/ANSI Standard 401 has been deemed as “incidental contaminants/emerging
compounds.”
Incidental contaminants are those compounds that have been detected in
drinking water supplies at trace levels. While occurring at only trace levels,
these compounds can affect the public acceptance/perception of drinking water
quality.
For Warranty, Filters, Help & More: PUR.com | 1-800-PUR-LINE (800-787-5463)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>