FLEXIT CI 600 Control Panel Installation Guide
- June 15, 2024
- FLEXIT
Table of Contents
FLEXIT CI 600 Control Panel
Dolt montage
Surface installation
Finish
CI600 overview
No.
- UP/INCREASE switch
- BACK/CANCEL/NO switch
- DOWN/DECREASE switch
- OK/YES switch
- HELP switch
- Display
- Indication of OPERATION/OK – Greenlight
- Indication of FILTER REPLACEMENT – Yellow light
- Indication of ALARM – Red light
CI600 in use
General
The control unit consists of a colour display, a touch panel and indicators
(LEDs). The unit communicates with the ventilation unit via a low-voltage
cable.
Standby mode
If the touch panel is not used, the control unit will, after a certain period,
enter idle mode, in which operating information will be displayed.
Time and date
- Outdoor air temperature
- Room temperature
- Current speed
- Additional heating activated/deactivated
- Daily/weekly timer active
Menu navigation
Buttons 1 and 3 are used to navigate through the menu lines. The cursor is illustrated by the line is light blue. If it is possible to make a selection on the current menu line, this is displayed with OK? to the right of the line. If a menu line contains a submenus, this is illustrated with a ‘>’ sign at the end of the line. If you select a function that has numerical values, the current value is displayed with a light blue cursor. The value is changed with buttons 1 and 3 If several values can be changed, the cursor with button The procedure is repeated until all values have been changed to the desired values. If you want to cancel a function or return to the previous menu screen, use the button Describe the current menu screen.
Start menu
When the system is started, a start menu is opened. The basic language and date settings are set in this menu. When this activity has been carried out, you choose to go to the main menu.
Operating status
In normal operation without problems, the green system is described in
subsequent sections.
CI600 main menu
Fan speeds
The main menu contains various choices. The biggest concern is fan speeds. The
speed selected is indicated with large fan symbols and bold font. To change
the speed, move the cursor with button 4 and the speed selected is highlighted
with large fan symbols and bold font.
Settings
Under the SETTINGS menu item, you can adapt the system as you want.
Temperature
Here you set the temperature for the air that enters the building. We
recommend adjusting the temperature to max 18° so that the air is mixed
optimally with the air already in the building.
Daily/weekly timer
****The programming of the timer begins by selecting the day. A new menu screen appears each day at time intervals. Adjust the start and stop times for each interval and then adjust the desired speed and temperature. To activate the interval, select a green tick. A red cross means that the interval is not activated. If necessary, then select another interval and repeat the procedure.
NB! The following rules apply to the programming: A time interval with a higher number can never be started before a previous one has The stop time can never appear before the start time. repeat the procedure for other days. When the timer is active, this symbol is displayed when the display enters idle mode. If there is no new time interval registered after return to the setting that was previously active.
Information and alarm
Filter
indicator 8 lights up and an information text appears. Follow the instructions
in the text menu. The yellow indicator will remain lit until the
Alarm
If a problem occurs in the operation of the ventilation unit, an alarm will be
triggered. The red indicator 9 lights up and information text appears in the
display. Follow the instructions in the text. When the error has been
corrected, the alarm will be reset in the alarm menu. The red indicator will
stay lit until the error has been corrected.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>