PremiumSpec 10-277V Selectable Surface Mount LED Panel Instruction Manual

PremiumSpec 10-277V Selectable Surface Mount LED Panel

WARNING

• Installation, service, and maintenance of luminaries should be performed by a qualified licensed electrician.
• Specifications are subject to change without notice.
• Do not handle powered fixtures when hands are wet when standing on wet surfaces, or in water.

CAUTION

• Check to make sure that all fixture connections have been properly made and that the fixture is grounded to avoid potential electrical shocks.
• Designed for use in 110-277V, 50/60 Hz protected circuits.
• Access above the ceiling is required.

NOTICE

• Suitable for damp locations.
• Suitable for suspended ceilings.

Installation Instructions

Step 1
Remove the surface mount plate from the luminaire.

Step 2
Turn off the power at the breaker panel and thread the power lines into the J-box.

Step 3
Align the holes on the surface mount plate with the screw holes on the j-box. Lightly tighten both 8-32 screws and rotate the plate to the right position. Tighten both screws. Next, use the provided plastic anchors and KA3.5*20 mm screws to secure the surface mount plate to the ceiling plane.

Step 4
Align the two longer hooks on the metal plate with the longer hole on the luminaire (Step Slightly move the luminaire forward and make sure the hooks are in the right position.

Step 5
Attach the safety cable to the plate.

Step 6
Thread the wire into the J-box.

Step 7
Connect the line to the black wire of the fixture, the neutral to the white wire, and the ground to the green wire.

Step 8
Move the CCT and Wattage selection switches to your desired settings.
IMPORTANT: Step 8 must be accomplished before Step 9 prevents easy access to the selection switches.

Step 9
Push the luminaire to the ceiling, making sure the four hooks are inside the luminaire until you hear a clicking sound.

Wiring Diagram

Compatible with 0-10V dimmers

The driver PURPLE (D+) to the dimmer+ (PURPLE), and the driver PINK (D-) to the dimmer- (PINK). Connect the wires with a terminal cap as shown in the wiring diagram. Incoming insulated dimming conductors shall have voltage rated at least equal to the branch circuit.

WARNING

• Before installing, servicing, or performing routine maintenance on this equipment, follow these general precautions.
• to reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.
• Proper grounding is required to ensure safety. Power must be turned off at the breaker before installation or maintenance.
• This product must be installed per the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
• Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.
• To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.
• Do not install damaged products. Inspect the luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
• These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance
• . Should further information be desired or should particular problems arise that are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>