phrozen Cure Mega S Post Curing UV Lamp User Guide
- June 15, 2024
- phrozen
Table of Contents
Phrozen Cure Mega S User Guide
Post-Curing UV Lamp
Cure Mega S Post Curing UV Lamp
Specifications
Product Dimension： 39.5 x 47.5 x 48.6 cm
Maximum Model Size： Ø25 x 30 cm
Fan Speed： 1700 rotations/min
Timer： 1‒120 min
Recommended time： Maximum 30 minutes/cycle
Input： AC 100-240 V ; 50/60 Hz
Weight：1 5 kg
Rated Power： 70 W
LED Wavelength： 405 nm
Light intensity： 22000±2000 μw/cm²
(measured on the turntable, 10 cm from side LEDs)
Before You Start
- Place the machine on a clean and level surface.
- Please make sure to wear protective goggles when handling the machine.
- Remove the rack when drying and curing large models.
Instructions
- Install the turntable into the machine and connect the power.
- Make sure the models have been thoroughly cleaned without any residual resin before curing.
- Place the model on the turntable or the rack and cover the door before starting the machine.
- Select 「Cure 」, 「Fan 」, or 「Fan + Cure 」 according to your needs.
- To have a better view of the models inside, feel free to turn the interior lights.
- Input the required time and press ENTER. It’s recommended to set max. 30 mins/cycle.
- Please remember to take out the model after the curing process ends.
Note :
- Freshly cured model might get hot; please remove it carefully.
- The recommended curing time of 30 minutes might not be suitable for every resin.
Please visit our Users Guide for more information.
Warning
- Disconnect the power cable before performing maintenance.
- DO NOT open the acrylic door while the machine is running.
- Avoid direct contact with uncured resin and other cleaning fluids to prevent allergies.
- In case of contact with uncured resin and alcohol (cleaning fluid), please rinse immediately with plenty of water.
|
---|---
https://phrozen3d.net/uK6Ka| https://lihi1.com/bQ3w0
|
https://lihi1.com/U7iyD| https://lihi1.com/naYk0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>