phrozen 25X30 Cure Mega Post Curing UV Lamp User Guide
- June 1, 2024
- phrozen
Table of Contents
phrozen 25X30 Cure Mega Post Curing UV Lamp
Specifications:
- Post-Curing UV Lamp
- Interior Light
- Side Acrylic Door
- Touch Panel
- Removable Rack
- Turntable
- Power Switch
Product Usage Instructions
Before You Start:
- Place the machine on a clean and level surface.
- Wear protective goggles when handling the machine.
- Remove the rack when drying and curing large models.
Instructions:
- Dry and cure models consecutively.
- Dry prints.
- Cure prints.
- Change timer settings as needed.
- Start the curing process.
- Return to the homepage for navigation.
- Monitor the remaining time during curing.
- Stop progress temporarily if required.
- End progress and return to the homepage after completion.
Note: Freshly cured models may be hot, handle with care. The recommended curing time of 30 minutes may vary based on the resin used. Refer to the User Guide for more information.
Warning: Disconnect the power cable before performing maintenance. Do not open the acrylic door while the machine is running. Avoid direct contact with uncured resin and cleaning fluids to prevent allergies. If contact occurs, rinse immediately with water. Use only the specified power cord set provided with the unit.
FAQ
- Q: What should I do if the curing time is not sufficient for my resin?
- A: Adjust the curing time according to the resin manufacturer’s recommendations. Refer to the User Guide for more information on adjusting settings.
- Q: Can I use a different power cord with the machine?
- A: No, only use the power cord set provided with the unit to ensure safe operation.
Parts
Specifications
- Product Dimension：39.5 x 47.5 x 48.6 cm
- Maximum Model Size：Ø25 x 30 cm
- Fan Speed：1700 rotations/min
- Timer：1‒120 min
- Recommended time：Maximum 30 minutes/cycle
- Input：AC 100-240 V ; 50/60 Hz
- Weight：15 kg
- Rated Power：70 W
- LED Wavelength：405 nm
- Light intensity：22000±2000 μw/cm2 (measured on the turntable, 10 cm from side LEDs)
Before You Start
- Place the machine on a clean and level surface.
- Please make sure to wear protective goggles when handling the machine.
- Remove the rack when drying and curing large models.
Instructions
- Install the turntable into the machine and connect the power.
- Make sure the models have been thoroughly cleaned without any residual resin before curing.
- Place the model on the turntable or the rack and cover the door before starting the machine.
- Select「Cure」, 「Fan」, or 「Fan + Cure」 according to your needs.
- To have a better view of the models inside, feel free to turn the interior lights.
- Input the required time and press ENTER. It’s recommended to set max. 30 mins/cycle.
- Please remember to take out the model after the curing process ends.
Note :
Freshly cured model might get hot; please remove it carefully. The recommended curing time of 30 minutes might not be suitable for every resin. Please visit our Users Guide for more information.
Warning
Disconnect the power cable before performing maintenance. DO NOT open the
acrylic door while the machine is running. Avoid direct contact with uncured
resin and other cleaning fluids to prevent allergies. In case of contact with
uncured resin and alcohol (cleaning fluid), please rinse immediately with
plenty of water. The included power cord set packaged with the main unit
cannot be used with electrical equipment other than the specified device
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>