CHAUVET DJ XAO-FREEDOMSTICK Wireless Lighting System User Guide

CHAUVET DJ XAO-FREEDOMSTICK Wireless Lighting System

Safety Notes

These Safety Notes include important information about installation, use, and maintenance of Freedom Stick X4.

ALWAYS

• Connect to a grounded circuit.
• Connect to operating voltages as specified on the product’s spec sticker.
• Disconnect from power before replacing the fuse.
• Disconnect from its power source during periods of inactivity.
• Use a safety cable when suspending overhead.
• Heed all restrictions and warnings on the spec sticker.
• Mount in a location with at least 20 in (50 cm) of ventilation.
• Replace the fuse with the same type and rating.
• Use a clamp with a captive bolt when a single hanging bracket is used.

In the event of a serious operating problem, stop using immediately.

DO NOT

• Open this product or attempt any repairs. It contains no user-serviceable parts.
• Look at the light source when the product is on.
• Use if the power cord is crimped or damaged.
• Disconnect by pulling on the power cord.
• Allow flammable materials close to the product when it is operating.
• Touch the housing when it is on.
• Block any ventilation holes/slots in the housing.
• Connect to a dimmer or rheostat.
• Carry the product by its power cord.
• Operate in temperatures higher than 104 (40?C).
• Expose to environments that exceed the Ingress Protection (IP) rating.
• Expose to rain or moisture.
• Use outdoors.
• Submerge.
• Leave outdoors for extended periods of time.
• Expose to corrosive environmental conditions such as temperature, humidity, salinity, pressure, radiation
• Set this product on a flammable surface.

FCC Compliance

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures

• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

What is Included

• 4 Freedom Sticks
• 4 Diffusion tubes
• 4 USB charging cables
• Multi-charger
• RFC remote
• Carry bag
• Quick Reference Guide

Battery Charge Notes

ALWAYS

• Charge using a manufacturer-provided charger while the product is powered off.
• Charge the battery in temperatures between 32?-95 (02-35).
• Allow a depleted battery to charge for a few minutes before turning on the product. If the battery is completely discharged, the device cannot be turned on immediately when the charger is connected.
• Keep at least 3 ft (1 m) distance to any heat source and away from flammable materials.
• Keep the lid of any charging case open while charging.
• Keep batteries away from children.
• Store batteries between 40-60% charge.
• Follow local regulations when disposing of batteries.
• Replace with an authentic Chauvet battery.

DO NOT

• Continue charging if the battery becomes hot, smokes, swells, or gives off an odor during charging.
• Leave the product unattended while charging.
• Deplete the battery below 10%.
• Charge the battery in a closed container.
• Charge for more than 24 hours.

Control Panel Description

value when in a function
< DOWN>| Navigates downwards through the menu list and decreases the numeric value when in a function
< ENTER>| Enables the currently displayed menu or sets the currently selected value into the selected function

Scan the QR code to access the product page, warranty terms, and the complete User Manual.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>