NiLIGHT JK-51A Compatible Front Bumper Installation Guide
- June 15, 2024
- Nilight
Table of Contents
JK-51A Compatible Front Bumper
Scan QR code to contact us
nilight.com/pages/contact
If you’re having an issue with the product or need technical support, Nilight
team is always here to help and make sure your 100% satisfaction.
Installation Instructions
-
Remove the air dam from the underside of the stock bumper by removing the 6 retaining clips (4 exterior and 2 inside the air dam) with a set of pliers.
-
Remove the factory fog light connections by pushing the tab in on the brown connector and gently pulling out.
-
Remove the eight bumper attachment nuts using an 18 millimeter socket. Break the bolts loose with a breaker bar and then finish removing with a ratchet.
-
If you are installing a winch, remove the frame cover. This requires removing the center pin from the two clips, then pulling the clips out.or some prefer to leave it on if not running a winch, with applicable bumpers.
-
You are ready to install the Nilight Front Bumper using the following parts:
INCLUDED COMPONENTS
(1) Bumper
(8) 12mm spring washers
(8) 12mm Flat washers
(2) 412 Hex head screws
(6) M12 Nuts
(2) D-Rings -
The Nilight front bumper has 3 bolts in each side. Those three bolts will slide directly into the same mounting holes the original bumper was removed from. The 4th hole in gach side will receive a bolt that came in the parts bag supplied with the bumper.
-
Now it’s time to bolt the bumper up into place Ideally, a second person would help hold the bumper into place.
-
Each of the 3 pre-installed bolts will attach with a flat washer lock washer and nut. All 8 bolts connections will be tightened as shown partially completed in the following pictures.
-
These wire instructions show you one way to run all 4 LED lights from the OEM fog light switch. Cut the OEM fog light sockets free from the OEM wire hamess and strip the ends still connected to the Jeep . You will not need the light socket of bulb for the new bumper Following pictures shows how the wiring connections will be made.
Nilight Heavy Duty Front Bumper w/ LED Lights (07-18 Wrangler JK)
Tools Required:
19mm Wrench & Socket / Flat Screwdriver or Panel clip pliers / Phillips
Screwdriver
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>