COSTWAY EP23664DE Air Cooler and Heater User Manual

COSTWAY EP23664DE Air Cooler and Heater

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.

Please give us a chance to make it right and do better! Contact our friendly customer service department for help first. Replacements for missing or damaged parts will be shipped ASAP!

INTRODUCTION

Thank you for purchasing our air cooler and heater. Each unit has been manufactured to ensure safety and reliability. Before first use, read the instructions carefully and keep them for further reference.

DIAGRAM

PERFORMANCE PARAMETERS

FUNCTIONS

• Principle of cool humidity: take cool water from the water tank by pump or synchronous motor, after reaching the top, the cool water will flow through the wetted pad, then blow off humid cool air rounding the wetted pad by the rotational wind wheel. Use the water evaporation principle.
• Warm : heated by PTC heater, high efficiency of conversion between electricity and heat, rapid heating
• Electronic control : safe and durable, attractive appearance.
• Adjustable speed and mode : have three speeds and modes, blow at a wide angle.
• Cool / humidify : adopt ice crystal refrigeration and air humidifying technology to cut down the temperature from the air vent and raise relative humidity, preventing air drying.
• Anion : purify and sterilize air by generating negative ions. Deliver wind at a wide angle: swing the blades automatically, and deliver wind at a horizontal wide angle. Also, you can swing the blades transversely manually, select the direction discretionarily.
• Far-range remote control: 6 meters far-range remote control, received at a 60-degree wide angle.
• Buzzer : vocalize when operating the effective keypad, use it conveniently.

ASSEMBLING AND WATERING

1. Assemble castors: put the appliance on a flat surface, take out the wrench from the foam box, and then assemble the castors.
   Attention: the back castors are with brakes, but the front ones are without. (map 1)

2. Watering: push the key on the door, open it draw out the water tank, then add water. (map 2)
   Attention:

   • a. Pay attention to the level of the water tank when adding water. (map 3)
   • b. The level of the water tank should not exceed the “MAX” scale at any time, when humidifying, the total level of the water tank should not be lower than the “MIN” scale.
   • c. Put ice or frozen ice crystal box in the water tank if you want to strengthen the efficiency of cooling, but the total level of the water tank should not exceed the “MAX” scale.

OPERATION

• ON/OFF: turn on the power switch at the back of the air cooler and heater, it will be ready, at the same time the buzzer reminds “Bi”. Press the key to start it, and the second press to shut it down.
• Speed : press the key, and start the air cooler and heater. The corresponding function changes as LOW follows when pressing serially:
• Mode : press the key, and choose the normal wind, natural wind, and sleeping wind circularly. Under the situation of normal wind, it has no corresponding indicator light shining, but others have.  (When warming it doesn’t have this function).
• Swing : press the key, the wind automatically swings horizontally and the swing indicator light is on. Cancel this function when pressing again. Swing the blades transversely manually, and select the direction discretionarily.
• Anion : press the key, and the anion generator works, and releases the anion, at the same time the anion indicator light is on. Cancel this function when you press it again.
• Timer : 8 hours timer design, each press adds 1 hour.
• Cool / humidify : press the key, if adding an ice crystal box, the temperature from the air vent can lower about 3°C after a few minutes. Cancel this function when pressing again.
• Warm : press the key, and start the function. The corresponding function changes as follows when pressing serially:

THE USE OF REMOTE CONTROL
Fit on two AA batteries, and it works. There are 8 keys on the remote control, and it has the same function as the control panel. Aim at the reception window of the remote control when you use it, the effective distance must be 6 meters. When the remote control is not in use, please put away it for use next time.

Attention:

• Do not mix the old battery with the new one in use.
• Please take out the batteries when not in use for a long time.

THE USE OF ICE CRYSTAL BOX
The ice crystal box has a particular feature of keeping cool, it can absorb heat and let the water temperature below the environmental temperature.

Using methods;

• Add water to the ice crystal box (not full) and put it into the refrigerator to make sure that it is iced absolutely
• Open the door, and put the frozen ice crystal box into the water tank.
• There are two ice crystal boxes, which can be used circularly.

CAUTION

1. Use as per the rating voltage.
2. Do not repair or remake the appliance by yourself, it should be repaired by the repairmen.
3. Do not operate the appliance with wet hands, in order to avoid damage.
4. If the supply cord is damaged, it must be replaced by qualified persons to avoid a hazard.
5. When the appliance is not in use, switch off and unplug it.
6. Do not insert foreign things into air outlets and inlets, in order to avoid damage.
7. Do not use the appliance near explosive and combustible gas. Avoid long-term direct solar radiation.
8. Use the appliance only on a flat surface.
9. Do not use outdoors.
10. The level of the water tank should not exceed the “MAX” scale at any time, when humidifying, the total level of the water tank should not be lower than the “MIN” scale.
11. After adding water to the water tank, do not tilt or knock over it when you put or move it. If you want to move, please push slowly from the side, in order to avoid spilling.
12. Do not turn over the appliance. If it is toppled over and there is some water in the body, you should unplug the power supply first. Then send it to the repair department or after-sales service and overhaul.
13. WARNING : In order to avoid overheating, do not cover the appliance. (Especially do not cover the PTC heater to avoid overheating).
14. Clean the appearance with a lightly damp cloth. Do not use any type of detergents or solutions. Do not rinse the appliance.
15. Do not make air outlets and inlets near the wall or curtain.
16. Do not knock or shake the body when using, otherwise it may cause stop automatically.
17. The water in the tank will easily metamorphose and has an odor in summer, please renew the water frequently.
18. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
19. Children should be supervised to ensure that they do not play with the appliance.
20. To avoid the risk caused by the instability of the unit, you must fix the unit firmly according to the manual book.
21. The heater must not be located immediately below a socket outlet.
22. Do not use this appliance in the immediate surroundings of a bath, a shower, or a swimming pool.
23. Do not use the air cooler and heater with a programmer, timer, or any other device that switches it on.
24. Should it be necessary to move the unit after the water has been added, roll gently to the required position and activate the bracket castors.

ELECTRIC PRINCIPLE DIAGRAM

CLEANING AND MAINTENANCE

WARNING : Ensure that the fan is switched off from the supply mains before removing the air filter screen.

1. Clean the air filter screen (map 1)
   Cut off the power supply, pull the handle of the air filter screen, and remove it from the appliance. Clean the air filter screen with neutral detergent and banister brush, then clean it with clear water. Finally, reinstall the appliance.

2. Clean the wetted pad (map2, map3)
   Cut off the power supply, take down the air filter screen, and then draw the wetted pad from support. Clean the wetted pad with neutral detergent and banister brush, then clean it with clear water. Finally, reinstall the appliance.
   Attention : the wetted pad must be installed horizontally, in order to avoid leaking.

3. Clean the water tank (map 4)
   Cut off the power supply, open the door, take out the water tank, clean it with neutral detergent, and wash it with clear water, then reinstall the appliance.

4. Clean the shell with neutral detergent and soft cloth.
   Attention : cut off the power supply when cleaning the appliance, as there is a high pressure in the body. Do not leave any water on the surface of the control panel.

MALFUNCTION AND MAINTENANCE

Repair the appliance under the situation as follows:

1. Abnormal action or no action. it is invalid by the above approach.
2. Abnormal action caused by ingress of water or corpus alienum.

ASSEMBLING AND WATERING

1. Assemble castors: put the appliance on a flat surface, take out the wrench from the foam box, and then assemble the castors on the bottom of the appliance.
2. Fixed Installation as follows:
3. Take out the product’s fixed frame and screw bag;
4. Fix one side of the frame with one screw on the back of the product
5. Fix the other side of the frame with a screw on the wall.

Follow Costway

Visit us : www.costway.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>