INMOTION K400 Transmitter Instruction Manual
- June 15, 2024
- INMOTION
Table of Contents
INMOTION K400 Transmitter
Copy from the original K400/404 Transmitter to a New Transmitter
Step 1
- Turn both Transmitters “Off” by pressing the EMO button.
Step 2
- Press X3 then press X4 alternately four times.
- The Status LED will flash red and green. Press X1 + X3 + X4 together at the same time for> 5 seconds.
- The “1” and “2” LED will flash rapidly, release the button.
Step 3
- Press X3 then press X4 alternately four times. The Status LED will flash red and green. Press X2 + X3 + X4 together at the same time for> 5 seconds. The “1” and “2” will stay on solid, release the button. Done!
- Make sure the distance between Transmitters is more than 2 feet while copying.
Copy from the original K400/404 Receiver to a New Transmitter
Step 1
- Power the Receiver. Press the SYNC. Button >3 seconds. The Status LED will flash.
- Warning against electrical voltage
Step 2
- Press X3 then press X4 alternately four times. The Status LED will flash red and green. Press X2 + X3 together at the same time for> 5 seconds. The “1” and “2” will stay on solid, release the button. Done!
- Make sure the distance between the Transmitter and the Receiver is more than 2 feet while copying.
Copy from original K400/404 Transmitter to a New Receiver
Step 1
- Power the Receiver. Press the SYNC. Button >3 seconds. The Status LED will flash.
- Warning against electrical voltage
Step 2
Press X3 then press X4 alternately four times. The Status LED will flash red and green. Press X1 + X3 together at the same time for> 5 seconds. The “1” and “2” will stay on solid, release the button. Done!
Make sure the distance between the Transmitter and Receiver is more than 2 feet while copying.
Specifications
| Contact Information | INMOTION Controls, Inc. |
|---|---|
| Phone | 888-501-2220 |
| Website | www.inmotioncontrols.com |
FAQ
What should be the minimum distance between devices when copying?
- Ensure there is a distance of more than 2 feet between devices during the copying process.
- How do I know if the copying process has been successful?
- The “1” and “2” LEDs will stay on solid, indicating that the copying process is complete. Then you can release the button.
- Is there a risk of electrical voltage during the copying process?
- Yes, there is a warning against electrical voltage when powering the Receiver, so take appropriate safety measures.
- Who do I contact for support?
- You can contact INMOTION Controls, Inc. at 888-501-2220 or visit their website at www.inmotioncontrols.com for support.
Using Instructions
Copy from an original K400/404 Transmitter to a New Transmitter
Copy from the original K400/404 Receiver to a New Transmitter
Copy from original K400/404 Transmitter to a New Receiver
CONTACT
- INMOTION Controls, Inc.
- www.inmotioncontrols.com
- 888-501-2220