LEGGE 991MF Mortice Lock Instruction Manual
- June 15, 2024
- LEGGE
Table of Contents
LEGGE 991MF Mortice Lock
Handing Guide
To Reverse Bolt
- Remove outer for end.
- Pull and rotate bolt 180° clockwise.
991MF Handing/Function Adjustment
V Series handing adjustment (Inside handle free)
To set for left hand
Push in and turn clockwise.
Set adjuster as shown.
To set for right hand
Push in and turn anti-clockwise.
Set adjuster as shown.
V9/V55
The Locking Bar must be down before installing.
To set for C Series (Both handles lockable)
Set adjuster as shown.
Install provided Anti-lockout screw, when used in conjunction with the 9A
Adaptor.
Mortice Instructions
- Cut mortice slot using template for correct size
- Fit lock into mortice, scribe around for end and remove wood to allow flush fit to door.
- Remove lock and use template to mark and drill holes to suit lock and furniture being used.
CHECK CAREFULLY:
DO NOT DRILL HOLES RIGHT THROUGH DOOR. THE FURNITURE MAY NOT COVER ANY HOLES THAT ARE INCORRECTLY DRILLED.
IMPORTANT
A MAXIMUM CLEARANCE OF 5mm IS RECOMMENDED BETWEEN LOCK FOR END AND STRIKER
PLATE FOR SECURITY REASONS.
990MF LOCKS ARE DESIGNED FOR USE WITH SPRUNG DOOR FURNITURE. THE USE OF
UNSPRUNG DOOR FURNITURE IS NOT RECOMMENDED.
Customers Support
Allegion (Australia) Pty Ltd
Phone 1800 098 094
Website www.allegion.com.au
Allegion (New Zealand) Limited
Phone 0800 477 869
Website www.allegion.co.nz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>