Leader WS23012 All In One Universal Travel 15W Wireless Charging Pad User Manual
- June 15, 2024
- Leader
Table of Contents
Leader WS23012 All In One Universal Travel 15W
Wireless Charging Pad User Manual
Functions:
- Built-in Type-C Input Cable
- Wireless Charging Surface
- iWatch Wireless Charging Surface
- LED Indicator
What’s included:
1 x Wireless Charging Pad
Instructions:
1. Wireless Charging Mobile phones and other electronic devices:
- Connect the built-in Type-C cable(1) to a power source. To achieve best performance, quick-charge power adapter is
- LED indicator (4) will glow RED when the device is in wireless charging
- Place the wireless charging supported device on the wireless charging surface(2),
- LED will glow BLUE when device is
- Phone will begin to charge automatically,
** Once fully charged remove the device.
Note: When wireless charging, if the LED a wireless charging device or there is an object between the device and charging surface interfering with the charging. process.
2. Wireless Charging a iWatch:
- Be sure the wireless charging pad is connected to a power
- Place the iwatch on the wireless charging surface(3) in the center groove of the wireless charging pad.
- The watch will begin to charge automatically, the wireless charging LED(4) will glow BLUE when
Once fully charged remove the device.
SAFET Y PRECAUTIONS
- WARNING-When using this product, basic precautions should always be followed:
- Read all the instructions before
- Never store or use this product in temperatures below 32°F(0°C) or above 115°F(45°C).
- Do not overcharge your The unit may become hot under excessive use. Remove your phone once it is fully charged. Never charge your phone for more than 7 hours at a time.
- To reduce the risk of injury, close supervision is required when the product is used near
- Do not expose the device to
- Do not use the device in excess of its output Overload outputs above the
- Do not use the device if damaged orexplosion or risk of injury.
- Do not disassemble the device. For professional. incorrect reassembly may
- or temperatures above 104°F may cause explosion.
- To ensure product safety, ensure that identical replacement
- Attachments on the back of your phone can impede the effectiveness of the wireless charger, and lead to You must remove attachments from the phone before charging on this device.
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired
***** Warning:
approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipmentthe interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located for operating in conjunction with any other antenna or transmitter.
IC Statement :
-
This device contains licence-exempt transmitter (s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
-
This device may not cause
-
This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
-
L’ appareil ne doit pas produire de brouillage;
-
L’ appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’ en compromettre le
Radio Frequency Exposure Statement for IC This equipment complies with I
exposure limits set forth for an uncontrolled environment. This equipment
shall be installed and operated with minimum distance 10 cm between the
radiator & body.
Cet équipement est conforme aux limites environnement non contrôlé. Cet
équipement doit être installé et utilisé avec une distance minimale de 10 cm
entre le radiateur et la
Name of the Distributor: Leedsworld Inc
Address of the Distributor: 400 Hunt Valley Road, New Kensington,
PA 15068 USA. WWW.PCNA.COM
FCC ID : 2BAUN-WS23012 IC : 30190-WS23012
Made in Laos