COSTWAY OP70610 Pool Protection Fence User Manual
- June 15, 2024
- COSTWAY
Table of Contents
USER’S MANUAL
Swimming Pool Fence
List of essential tools needed before installation
- Hammer drill
- ®17×100 mm SDS masonry drill bit
- Measuring tape
- Chalk
- Rubber mallet
- Level
| PART# | DESCRIPTION | QUANTITY |
|---|---|---|
| A | Pool fence | 1 |
| B | Drilling template | 1 |
| C | Safety latch | 1 |
| D | Plastic sleeve cap | 1000% |
| E | Plastic sleeve | 5 |
Installation steps
- Draw a chalk line around the perimeter of the pool, preferably 76 CM away from the pool edge.
- Decide the opening of your pool, and mark “X” on the pool deck with chalk for placement of the initial pole.
- Take out the drilling template, carefully align spot “A” with the mark “X”. Then check to make sure that the template is straight and aligned with the chalk line, and then mark “B” and “C” (also 76 CM away from the pool edge). Ensure the template does not move, drill through spot marked “A”,” B” and “C”. All holes should be drilled to a depth of 10 CM, and at a direct 90-degree angle to the deck. ( Please note, the spot marked “A” and “B” is where the opening of your pool fence will be. The two poles that fit into these holes will need to be joined with “safety latch”.
- Continue around the entire pool, drill all holes using the drilling template for guidance. Place the “B” hole marked on the drilling template over the last hole drilled. (see figure 2), then drill through the “C” hole. Repeat this step for every 3.7 M (or at the end of each fence unit), you must also drill through the “A” hole to accommodate the pole from the new fence unit.
- When you have completed all the holes, clear the holes of any drilling dust. Insert the plastic sleeve into the holes. Always insert the feet with care, so as not to damage them. Confirm that plastic feet fit snugly into the holes. If you are having trouble getting the feet to fit into the holes, tap them gently into place with a rubber mallet.
- Attach Safety Latch to end of each fence section, using the pre-drilled holes in the pole. Inserting your safety fence into the plastic sleeve. Fasten each section to the next with the safety Latch.
- Hose down pool deck to rinse away any chalk marks or drilling dust. If safety fence will be removed for an extended period of time, use enclosed plastic caps to seal holes in the ground. This will insure that the holes with the plastic feet inside do not fill up with any dirt or debris. Simply remove fence from holes, taking care to leave plastic feet in the holes. Insert the caps into the feet.
http://www.costway.com/hysalesrule/qr
Read User Manual Online (PDF format)
Loading......