KICHLER 55163NI Fixture Solia LED 24 inch Brushed Nickel Instruction Manual
- June 15, 2024
- KICHLER
Table of Contents
KICHLER 55163NI Fixture Solia LED 24 inch Brushed Nickel Instruction Manual
FIXTURE DIAGRAM
PARTS LIST
-
[A] Mounting Strap
-
[B] Outlet Box
-
[C] Strap
Mounting Screw (2) -
[D] Mounting Screw (4)
-
[E] Canopy
-
[F] Glass Shade
-
[G] Socket Base Cup
-
[H] Socket
-
[I] Candle Sleeve
CAUTIONS
CAUTION RISK OF SHOCK: Disconnect Power at the main circuit breaker panel or
main fusebox before starting and during the installation.
WARNING:
- This fixture is intended for installation in accordance with the National Electrical Code (NEC) and all local code specifications. If you are not familiar with code requirements, installation by a certified electrician is recommended. Failure to adhere to these codes and instructions may result in serious injury and/or property damage and will void the warranty.
CLEANING:
- Always be certain that electric current is turned off before cleaning.
- Only a soft damp cloth should be used. Harsh cleaning products may damage the finish.
INSTALLATION INSTRUCTIONS
-
Attach mounting strap[A] to outlet box[B] using the strap mounting screws[C]. Mounting strap can be adjusted to suit position of fixture.
NOTE: Mounting strap should be installed with the bent tabs at the outer edge of the mounting strap pointing away from the wall, at the 12 and 6 o’clock position as shown. -
Grounding instructions: (See Illus. a or b).
a. On fixtures where mounting strap is provided with a hole and two raised dimples, wrap ground wire from outlet box around green ground screw, and thread into hole.
b. On fixtures where a cupped washer is provided, attach ground wire from outlet box under cupped washer and green ground screw, and thread into mounting strap.
If fixture is provided with ground wire, connect fixture ground wire to outlet box ground wire with wire connector after following the above steps. Never connect ground wire to black or white power supply wires. -
Make wire connections. Reference chart below for correct connections and wire accordingly.
-
Push canopy[E] to wall, carefully aligning the mounting screw holes in top and bottom of mounting strap with the mounting screw holes in top and bottom of canopy.
NOTE: Fixture should be mounted with glass shade in the UP position ONLY. Make sure all wires are inside canopy and do not get pinched between mounting strap and canopy or wall and canopy of fixture. -
Screw four (4) mounting screws[D] into holes in canopy and mounting strap to attach fixture to wall. Two at the top and two at the bottom of canopy. Tighten to secure.
-
Carefully slip small hole in glass shade[F] over socket[H]. Make sure base of glass shade is fully seated in socket base cup[G].
-
While holding glass shade in place on socket base cup, carefully slip candle sleeve[I] over socket, and seat on inside of glass shade to secure glass shade.
-
Repeat steps 6 and 7 for remaining sockets.
-
Insert recommended bulb(s) (not included)
For warranty information please visit: kichler.com/warranty
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>