amazon commercial B083V3F1FH Compact Humidity Meter User Manual
- June 15, 2024
- amazon commercial
Table of Contents
**amazon commercial B083V3F1FH Compact Humidity Meter User Manual
**
IMPORTANT SAFETY INSTRUCTIONS
Read these instructions
carefully and retain them for future use. If this product is passed to a third
party, then these instructions must be included.
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:
CAUTION
Risk of injury! The pin-type probes are very sharp. Be careful while handling.
Cover the pins with the protective cap when the product is not in use. In
addition, the pin-type probes can damage the measured surface.
- Do not use if the product appears damaged or if it is not working properly. If in doubt, replace the product.
- Do not attempt repairs. There are no user serviceable parts.
- Do not expose the product itself to moisture. Otherwise the product can get damaged.
Battery Warnings
- Always insert batteries correctly with regards to polarity (+ and -) marked on the battery and the product.
- Do not mix old and new batteries or batteries of different types or brands.
- Exhausted batteries should be immediately removed from product and properly disposed.
- Keep batteries out of the reach of children.
- Do not dispose of batteries in fire.
- Remove batteries from product if it is not to be used for an extended period of time.
- If the battery leaks avoid contact with skin and eyes. Rinse affected areas immediately with plenty of clean water, then consult a doctor.
CAUTION
Never put batteries in mouth. If swallowed, contact your physician or local
poison control center
Explanation of Symbols
This symbol stands for “Conformité Européenne”, which means “Conformity with EU-directives”. With the CE marking the manufacturer confirms that this product complies with applicable European directives and regulations.
Intended Use
- This product is intended for measuring moisture content in wood, paper, cardboard and building structures (wood, mortar, concrete or plaster).
- This product does not provide a replacement for an officially calibrated measuring device.
- This product is intended to be used in dry areas only. Do not use it in rainy conditions.
- No liability will be accepted for damages resulting from improper use or non-compliance with these
- instructions.
Product Overview
-
Protective cap
-
Pin-type probe
-
Display
-
on/off button
-
MODE button
-
Wrist strap
-
Battery compartment cover
-
Battery compartment
-
Moisture data
-
Temperature value
-
Unit indicator
-
Building material mode indicator
-
Auto Power Off (APO) mode indicator
-
Low battery indicator
-
Wood material mode indicator
Changing Batteries
NOTICE
Replace the batteries when the low battery indicator is shown on the display.
- Remove the battery compartment cover.
- Place 4 x button cell batteries (LR44) into the battery compartment observing the correct polarity.
- Put the battery compartment cover back in place.
Operation
Switching the product on
Press and hold the on/off button for 2 seconds. The display lights up.
Switching the product off
Press and hold the on/off button for 2 seconds again. The display goes off.
Auto power-off (APO)
- This product switches off automatically after 2 minutes of inactivity by default.
- The APO mode is active when the icon is shown on the display.
- To deactivate the APO mode press and hold the MODE button while the product is switched off and then press the on/off button U to switch the product on. The icon not shown on the display which indicates the product will not switch off automatically. You need to switch off the product manually.
Changing the units
Press and hold the MODE button for 1 second to change the measurement
unit.
Changing the modes
Press the MODE button to toggle between wood Q and building material f§ moisture measurement mode.
Backlight
Press the on/off button to turn the back light on or off.
Memory function
The product memorizes the latest setting (unit, material and back light) after
switching off. When the product is switched on the previously used settings
will be ac
Measuring tips
- Measure several spots and take an average value.
- Remove the bark from firewood if needed. Press the measuring pins against the grain in various places on the wood.
- Ensure that both measuring pins touch the surface of the material at the same time. Slightly increase the pressure on the measuring pins for rough surfaces.
- For delicate surfaces complete the measurement on a section that is not in the visible area.
Measuring
- Remove the protective cap.
- Press the measuring pins into the material. The measured moisture value is shown on the display.
Cleaning and Maintenance
NOTICE
switch the product off before cleaning.
NOTICE
During cleaning do not immerse the product in water or other liquids. Never
hold the product under running water.
Cleaning
- To clean the product, wipe with a soft, slightly moist cloth.
- Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.
Storage
- Always attach the protective cap when the product is not in use.
- Store the product in its original packaging in a dry area. Keep away from children and pets.
Battery Disposal
Do not dispose of used batteries with your household waste. Take them to an appropriate disposal/collection site.
Disposal
The Waste Electrical and Electronic Equipment (WEEE) Directive aims to minimise the impact of electrical and mmm clectronic goods on the environment, by increasing re-use and recycling and by reducing the amount of WEEE going to landfill. The symbol on this product or its packaging signifies that this product must be disposed separately from ordinary household wastes at its end of life. Be aware that this is your responsibility to dispose of electronic equipment at recycling centers in order to conserve natural resources. Each country should have its collection centers for electrical and electronic equipment recycling. For information about your recycling drop off area, please contact your related electrical and electronic equipment waste management authority, your local city office, or your household waste disposal service.
Feedback and Help
Love it? Hate it? Let us know with a customer review.
Amazon Commercial is committed to delivering customer-driven products that live up to your high standards. We encourage you to write a review sharing your experiences with the product.
amazon.co.uk/review/review-your-purchases#
amazon.co.uk/gp/help/customer/contact- us
Specifications
ASIN: BO83V8F1FH
Model number: 50EN200
Measuring principle: Electrical resistance
Measuring range:
Wood: 6-44%
Material: 02-2%
Display resolution:
Wood : 1%
Material: 0.1 %
Temperature: 1 °C
Accuracy:
Wood: +2%
Material: +0.2 %
Temperature: + 1 °C
Auto power-off: After approx. 2 minutes
Power source: 4 x LR44 battery
Housing material: Impact-proof plastic housing
Operating temperature: 0-50°C
Operating relative humidity: 0-85%RH
MADE IN CHINA
Documents / Resources
|
amazon commercial B083V3F1FH Compact Humidity
Meter
[pdf] User Manual
B083V3F1FH Compact Humidity Meter, B083V3F1FH, Compact Humidity Meter,
Humidity Meter, Meter
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>