SEBSON LED Spiegellamp 60cm Instruction Manual

LED Spiegellamp 60cm
Instruction Manual

MIRROR_WAL_12W

Thank you for choosing a product of SEASON. Read the instructions carefully and keep them looking up before start-up this product. A long and failure-free operation can only be guaranteed if the installation and start-up is done properly. Before starting up this product, please check for external damage. In case of visible external damage, we immediately dis-advise the start-up of this product! Please remove all packaging material of this product before the first start-up and check the content for completeness!

Intended use:
This mirror luminaire of the SEASON brand is suitable for mounting on the wall or ceiling, for example. Due to its nature, it has a protection class of IP44 and is, therefore, suitable for use in damp rooms.

Scope of delivery:

• 1 Mirror light
• 2 Screws and 2 Dowels (Ø 6mm) for fixing

General safety information:

Danger: The installation of this product may be done only by a qualified person according to the valid regulations for electrical installation!
Danger: In case of damage or contact with water turn off this product immediately without tension and make sure that a restart is no longer possible!
The danger of suffocation: Keep this product away from children and animals! The packaging contains small parts that can be swallowed!
Caution: Please set up the light beam of the light never directly at people or animals to prevent fire damage or eye damage and avoid looking directly into the light source!

• An exchange of the built-in luminous in the light is not possible!
• The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer be guaranteed if it is modified! In addition, this will invalidate the warranty claim!
• Do not connect a dimmer as this may cause damage to the lamp.
• Do not cover the light with heat-insulating materials! As a result of a strong heat development, the LED can be damaged!
• The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of this product!
• Any other use than the description may result in damage to the product. So the dangers are such as electric shock, short circuit, fire, etc.
• We reserve the right to make changes to the product, the packaging, or the operating instructions as well as printing errors.
• Protect the product from external damage, heavy dirt, moisture, and excessive heat!
• In order that the warranty claim does not expire please use only the supplied items. Repairs may only be done by an expert and only by using original spare parts!
• In commercial institutions, the accident prevention regulations of the professional trade association for electrical equipment and facilities must be adhered to.

Instruction for installation (Fig 1):

Danger: Before installing make sure that the circuit is interrupted! For installation, work on the mains voltage is required. Remove the associated mains fuse or deactivate the switch fuse! Check by using a voltage tester if the line is de-energized. Make sure that the current circuit will not close during the installation! There is a danger to life here!

Danger: The installation of this product may be done only by a qualified person according to the valid regulations for electrical installation!
Attention: Before drilling the mounting holes, make sure that there are no gas, electricity, or water pipes at the drilling location that could be damaged by this!

• This product is only suited for indoor use and not for outdoor use!
• Plan a minimum distance of 50cm between the illuminated area and the lamp.
• Observe the safety instructions and technical data before installing this product!
• Note on installation:
  L: Live wire (black)
  N: Neutral conductor (blue or grey)

Technical Data:

This product contains a light source of energy efficiency class G

Disposal note:

This product may not be disposed of with household waste. At the end of its useful life, the product must be returned to a point of acceptance for the recycling of electric and electronic devices. Please ask your local municipality for the point of acceptance! As the devices contain valuable recyclable materials, they should be sent for recycling, in order not to harm the environment or human health from uncontrolled waste disposal.

Cleaning:
Danger: Before starting cleaning the product interrupt the current circuit by switching off the circuit breaker or unscrewing the fuse! Use a slightly moistened cloth for cleaning. In order not to damage the product, it is essential to avoid water penetrating into the housing! Never clean the device under running water! Do not use solvent-containing cleaner for cleaning.

SEBSON
Sebastian Sonntag
Gernotstr.17
44319 Dortmund
Germany
support@sebson.de
VAT-Nr.: GB179436663
WEEE-Reg.-ID.: 500617

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>