MOUNTUP TPMMA02112W Dual Monitor Wall Mount Instruction Manual
- June 15, 2024
- MOUNTUP
Table of Contents
MOUNTUP TPMMA02112W Dual Monitor Wall Mount
Specifications
- Model: Dual Monitor Wall Mount
- I nstruction Manual: Included
- Compatibility: 75x75mm and 100x100mm VESA mounting patterns
- Load Capacity: Not specified
- Product Code : 80002-MA02-114W-US2.0
WARNING
If you have any confusion or are not quite sure about the installation, please
do not hesitate to ask for our help.
Before assembly, please check and make sure all necessary accessories are
included and undamaged. Improper installation, such as using the product for
monitors over its load capacity or for any purpose not explicitly specified,
may cause damage or serious injury. We would not be liable for any damage or
injury caused by improper mounting or inappropriate use. DO NOT install into
drywall alone.
The kit contains small items that could be choking hazards if swallowed.
Please keep them OUT OF REACH OF
CHILDREN UNDER 3 YEARS OLD. ADULT SUPERVISION IS REQUIRED.
PACKAGE CONTENTS
Installation Tools (Not Included)
ASSEMBLY STEPS
STEP 1: Attach Arm to Wall
STEP 2: Attach Decorative Cover
Attach Decorative Covers (D) to Lag Bolts (W-A).
STEP 3: Attach Monitor
OPTION A: Flat Back Monitor
Attach the VESA plate (B) to the back of monitor and secure it by using a 6 mm
Allen Key (E) to tighten screws (M-A).
Do not tighten the screws excessively or your monitor might be damaged.
OPTION B: Curved Back Monitor Attach the VESA plate (B) to the back of the monitor and secure it by using a 6 mm Allen Key (E) to tighten screws (M-B) along with spacers (M-C).
WARNING: Do not tighten the screws excessively or your monitor might be damaged.
STEP 4: Hang Monito
Slide the monitor onto the head of the swivel arm, and install the security
bolt (C). Make sure the security bolt is installed before you rotate the
monitor.
Guideline to adjust monitor tilting angle.
STEP 5: Adjust Tension
For the intended functioning of the mount, you may need to adjust the tension
of Arm (A) by your monitor weight by 6 mm Allen Key (E)
Note 2: For how many circles the screw should be turned, please refer to the table below.
STEP 6 : Cable Management
Remove the bottom plastic covers from the gas spring arm as shown in the
diagram
- Run cables from the monitor through the bottom of the gas spring arm.
- Reattach plastic covers as shown in the diagram.
Adjust as Desired
Adjust monitor position and rotation.
Note: To ensure stability, the tightness of the rotating axis has been
preset, so it would be kind of difficult to rotate the VESA plate.
Suggestion: Please attach the monitor first, then hold the sides of it
with both hands and rotate vigorously. If that doesn’t work out, please do not
hesitate to ask for our help.
Product Dimensions
CAUTION AND MAINTENANCE:
- Never allow children to climb, stand, hang, or play on any part of the monitor or stand.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
- Check that the bracket is secure and safe to use at regular intervals (at least every three months).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>