ASSA ABLOY CEX100 Limited Modular Transmitter Instructions
- June 15, 2024
- ASSA ABLOY
Table of Contents
CEX100 Limited Modular Transmitter
Integration Manual
CEX100 Limited Modular Transmitter
The CEX100 Module is only intended for Assa Abloy products.
The CEX100 PCB transmitter module and plastics are assembled at an Assa Abloy
contract manufacturer. Assa Abloy provides all programming and test fixtures
to our supplier to ensure the limited modular assemblies remain compliant.
Calibrated, commercial test equipment is used to measure the RF parameters.
Final assembly of the Module into the Host Products and Host Product testing
are done at an Assa Abloy factory per our factory process.
For additional hosts other than the specific host originally granted with this
limited module, a Class II permissive change is required on the module grant
to register the additional host as a specific host also approved with the
module.
Applicable FCC Rules:
FCC Part 15, Subpart C, Sections 15.225, 15.247 and 15.209
Applicable ISED Rules:
ISED Canada RSS-210 Issue 10 Annex B.6, RSS-247 Issue 2 and RSS-GEN Issue 5
Section 8.9
Host Labelling Instructions:
The module is labelled with its own FCC and IC certification numbers that are
not visible when inside the host.
Therefore, when the module is installed into the host a label containing the
following shall be applied in a visible area on the back of the Host assembly.
Contains:
FCC ID: U4A-CEX100
IC: 6982A-CEX100
Warning: Changes or modifications to this device are strictly prohibited.
Avertissement : Tout changement ou modification à cet appareil est
strictement interdit.
This device complies with part 15 of the FCC Rules. This device contains
licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The final host product still requires Part 15 Subpart B compliance testing
with the modular transmitter installed.
RF Exposure:
The antenna(s) used for this module must be installed to provide a separation
distance of at least 15 mm from all persons and must not be collocated or
operated in conjunction with any other antenna or transmitter.
23 May 2023
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>