MDCMDCM TG-TY051 Solar Flood Lights Outdoor Waterproof Motion Sensor User Manual
- June 14, 2024
- MDCMDCM
Table of Contents
MDCMDCM TG-TY051 Solar Flood Lights Outdoor Waterproof Motion Sensor User
Manual
NOTE: Please read the user manual carefully before processing use and installation
Solar Motion Sensor Light
-
Remote Control
-
4 X Wall Anchors
-
4 X Mounting Screws
Specifications
Name: Solar light with motion sensor
Battery: Built-in 3.7V 2400mAh lithium battery
Sensing distance： 3-7 m
Waterproof： IP65
Material： ABS
Delay time： 20 seconds
Solar panel： 5.5V 1.8W
Working mode : 3 modes
Before use
- Expose the solar panel under sunshine totally for more than 8 hours to ensure sufficient charge. Switch on before installation.
Installation
install the light at the height of 3-7 meters. Make sure it is totally exposed under sunshine and switch on.
Features
- Large capacity battery & unique low light mode to make it long lasting.
- Auto on/off, motion sensor and 3 lighting modes.
- Waterproof, remote control, easy to install and maintain.
Fault removal
lf the light does not work, please follow below:
- Check the switch, make sure it’s ON.
- Check the location you mount the device and make sure the solar panel is expose under the sunshine totally during the daytime.
- Make sure the battery is fully charged. It takes 8 hours to get it sufficiently charged.
Light modes
You can change the light mode by using remote control or pressing the switch.
-
Press the switch button for the first time to enter Mode 1: When people come, the light turns on at 100% brightness. The light turns off 20 seconds after people leave.
-
Press the switch button for the second time to enter Mode 2: When people come, the light is at 100% brightness. The light is always on at 10% brightness 20 seconds after people leave.
-
for the third time to enter Mode 3: The light stays on at 30% 3.Press the switch button brightness at night without infrared induction.
Installation Instruction
-
Remove the bracket of the solar sensor light. Punch holes in the wall. Then use a hammer to drive the wall anchors into the punched hole.
-
Align the bracket to the hole, and use a screwdriver to fix the screw on the wall.
-
The bracket is installed.
-
Install the lamp on the fixed bracket.
-
Complete installation.
-
Freely adjust the illumination angle of the lamp.
Product Warranty
We provide our lamp with a 12 months limited warranty from the date of purchase. To make a warranty claim please contact the seller you purchased this light from.
Warranty Limitations
The following are not covered by our warranty:
- Purchases from non-authorized sellers or distributors.
- Damage resulting from fire, moisture, improper use, physical shock or other damage occurring after purchasing the lamp.
- If the item has been dismantled or modified after purchase.
EMAIL: cs@mdcmdcm.net
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>