BONTEC CT135B TV Wall Bracket Instruction Manual
- June 14, 2024
- BONTEC
Table of Contents
BONTEC CT135B TV Wall Bracket
UNPACKING INSTRUCTIONS
- Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.
- Check package contents against the Supplied Parts List in the next page to assure that all components were received undamaged. Do not use damaged or defective parts.
- Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained
herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
- If you don’t understand these directions or have any doubts about the safety of the installation.
- If you are uncertain about the nature of your wall, consult a qualified installation contractor.
Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaim any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
CAUTION! This TV mount must be securely attached to the vertical wall. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.
Tools Required
- 4mm Drill Bit
- Phillips Screwdriver
- 10mm Masonry Bit
- Stud Finder
- Wrench or Socket Set
- Carpenter’s Level
Note: The mounting components and hardware supplied in this package are not designed for installations to walls with steel studs or to cinder block walls. If the hardware you need for your installation is not included, please consult your local hardware store for proper mounting hardware for the application.
Supplied Parts List
INSTALLATION
Before getting started, let’s make sure this mount is perfect for you!
- Is your TV VESA equal to/greater than 100x100mm and equal to/less than 600x400mm?
- What is your wall made of?
STEPS
- Mounting the Wall Plate to the Wall
- Install VESA Plate to the back of TV
- Final lnstallation
- Tilting And Level adjustment
Thank you for choosing our products.