BONTEC KMT01 Black Clamp On Keyboard Tray Instruction Manual
- June 15, 2024
- BONTEC
Table of Contents
BONTEC KMT01 Black Clamp On Keyboard Tray
Specifications
- Importer: CT Global UK Limited
- Address: Tower House Lane, Hedon Road, Hull, UK, HU12 8EE
- Telephone: +44 (0)1482 895320
- Fax: +44 (0)1482 280189
- Maximum load capacity: 11 lbs
WARNING!
If you do not understand these directions, or if you have any doubts about the
safety of the installation, please call a qualified technician. Check
carefully to make sure there are no missing or defective parts. Improper
installation may cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual. Do not exceed
weight capacity. We cannot be liable for damage or injury caused by improper
mounting, incorrect assembly, or inappropriate use.
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS
REQUIRED.
PACKAGE CONTENTS
ASSEMBLY STEPS
STEP 1: Combine the left keyboard board (E) and the right keyboard board (F), and use the connecting board (D) on the reverse side to tighten the countersunk screws (B) with a screwdriver.
Please do not fully tighten the screws (B) before the two keyboard boards (E&F) are aligned. If the two keyboard boards(E&F) are not yet aligned, please unscrew the screws (B), align the two boards and then tighten the screws (B) again.
STEP 2: Use the ST4.2X9.5 pan-head tapping screw (A) on the back of the keyboard baffle (I) to tighten the keyboard board with a screwdriver.
STEP 3
Use M5X12 round head screws (C) to install the clamps (G, H) on the slider,
and tighten with a screwdriver.
Note: P lease do not swap around part (G )and part (H). The opening of C-Clamps faces the direction of Safety Lodge Stopper.
STEP 4: Place the assembled keyboard tray on the edge of the table and tighten the clamp.
Please make sure that your desk surface does not exceed a thickness of 1.57 inch
STEP 5 Correct Usage Methods
