BONTEC KMT01-HD Black Clamp On Keyboard Tray Instruction Manual
- July 26, 2024
- BONTEC
Table of Contents
BONTEC KMT01-HD Black Clamp On Keyboard Tray
Product Specifications
- Importer: CT Global UK Limited
- Address: Tower House Lane, Hedon Road, Hull, UK, HU12 8EE
- Telephone: +44 (0)1482 895320
- Fax: +44 (0)1482 280189
- Model: KMT01-HD
- Maximum Load Capacity:
Instruction
- Arc or special-shaped desks cannot be installed.
- Desks with aprons cannot be installed.
- Desktops with sloped edges are not compatible.
- Tables with drawers are not suitable for installation.
- Avoid installing on tables with raised edges.
- Rounded edge desktops are not suitable for installation.
Frequently Asked Questions (FAQ)
Q: What is the maximum load capacity of the product?
A: The maximum load capacity is 11 lbs.
Black Clamp-on Keyboard Tray
Instruction Manual
WARNING!
If you do not understand these directions, or if you have any doubts about the
safety of the installation, please call a qualified technician. Check
carefully to make sure there are no missing or defective parts. Improper
installation may cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual. Do not exceed
weight capacity. We cannot be liable for damage or injury caused by improper
mounting, incorrect assembly or inappropriate use.
WARNING: CHOKING HAZARD SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT
SUPERVISION IS REQUIRED.
PACKAGE CONTENTS
ASSEMBLY STEPS
-
STEP 1
Combine the left keyboard board (El and the right keyboard board (Fl, and use the connecting board (Dl on the reverse side to tighten the countersunk screws (Bl with a screwdriver. -
STEP2
Use the ST4.2X9.S pan-head tapping screw (A) on the back of the keyboard baffle (I) to tighten the keyboard board with a screwdriver. -
STEP3
Use MSX12 round head screws (C) to install the clamps (G, H) on the slider, and tighten with a screwdriver. Note: Please do not swap around part (G )and part (H). The opening of C-Clamps is facing the direction of Safety Lodge Stopper. -
STEP4
Place the assembled keyboard tray on the edge of the table and tighten the clamp. Please make sure that your desk surface does not exceed a thickness of 1.57 inch -
STEP 5
Correct Usage Methods
Incompatible Desktop Types
- Arc, special-shaped desk cannot be installed
- Desk with aprons cannot be installed.
- The edge of the desktop has a slope and cannot be installed
- Tables with drawers cannot be installed
- Do not install on the table with raised edges
- The edge of the desktop is rounded and cannot be installed
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>