Ultenic FS1 Cordless Stick Vacuum Cleaner with All Around Station User Manual

Ultenic FS1 Cordless Stick Vacuum Cleaner with All Around Station

Important Safety Instruction
Basic precautions should always be observed when using any electrical equipment, including the following:

WARNING:
READ ALL SAFETY INSTRUCTIONS AND THE ENTIRE MANUAL. Failure to heed the warnings and instructions may result in electric shock, fire, or serious injuries. Please read all instructions before using this device.

WARNING:
This device is intended for children 8 years of age and older. People with reduced physical, sensory, or intellectual abilities, or those who lack experience and knowledge, should be supervised or instructed in safely using the device; they must also be aware of possible hazards. Children should not play with this device. Cleaning and user maintenance should not be performed by children without supervision.

To reduce the risk of injury or damage, please observe the following safety precautions when installing, using and maintaining the device:

• Please read all instructions regarding safety and operation before using the device.
• Keep the safety and user manual for future reference. If you accidentally lose the manual, you may visit the official website to download the electronic version. (http://www.ultenic.com).
• Follow all operating and usage instructions.

The product’s labels or packaging indicate that:

Do not dispose of the electrical appliances as unsorted waste or, use a separate waste collector. Contact your local authority for information on the appropriate disposal method. If electrical appliances are discarded in landfills, hazardous substances can leach into groundwater, enter the food chain, and damage people’s health. Contact your local or regional waste management agency for more information on their recycling and reuse programs.

Restrictions

• Please read all contents of this manual carefully before using this product.
• Please do not use the Vacuum Cleaner to vacuum detergent, kerosene, glass dregs, needles, wet items, sewage, matches and other items.
• Please do not use the Vacuum Cleaner to vacuum toys, paper balls and other large objects, otherwise it will cause blockage of the Vacuum Cleaner, motor burnout and other failures.
• Please keep the Vacuum Cleaner away from fire and other hot places.
• Please make sure to install the filter modules and the roller brush of the floor brush.
• Please make sure not to block the suction inlet or block the brush rollers, as this may cause motor failure when using the Vacuum Cleaner.
• Please do not pour or spill water or other liquids into the machine to avoid short circuit and burn out the machine.
• Please fully charge the battery when using a new battery or the battery used for the first time after long-term storage. Please ensure that it is charged and discharged at least every three months when the machine is not used for a long time.
• The appliance is only to be used with the power supply unit provided with the appliance.
• The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.
• When cleaning the Vacuum Cleaner, use a dry cloth to wipe it. Do not use gasoline, banana water and other cleaners that are easy to crack or fade the shell.
• Please do not use or store the Vacuum Cleaner and Auto Empty Base in high temperature, low temperature and other adverse conditions, and do not use them outdoors or on wet surfaces. It is recommended to use them indoors at an ambient temperature of0-30 °C. Please store it in a cool and dry place, and do not expose it to sunlight for a long time.
• Do not allow children to use or play with the Vacuum Cleaner and Auto Empty Base.
• When the Vacuum Cleaner and Auto Empty Base can not work, it must be tested and repaired at the designated service centre. Do not disassemble the machine by yourself. Waste battery packs should be safely recycled and disposed of, please do not dispose of them at will.
• If the power cord is damaged, in order to avoid danger, you must go to the manufacturer’s local maintenance department or similar department to have it replaced by a professional.

Overview

• Electric Floor Brush:
  The electric floor brush head can be used to clean hard floors, floor tiles or short pile carpets, etc. It is recommended to use with a metal extension tube for a better experience.

• Crevice Brush :
  Insert the head into the suction socket, fix it and you are ready to use. Can be used to clean ceilings, bookshelves, computer keyboards and narrow crevices that are not easy to clean, etc.

• Round Brush:

1. Directly connected to the Vacuum Cleaner can be used to clean the desktop, cabinet surface, sofa, short hair carpet and other vacuum cleaning.
2. Connected to a metal extension tube can be used to clean high places such as ceilings and curtains.

Operation

Assemble Vacuum Cleaner Parts

Battery Assembly & Disassembly

• Assembly : The battery and the Vacuum Cleaner are first aligned, then pulled back and hear a click, the assembly is in place.
• Disassembly : Press the battery release button down first, then push it forward, the battery will be removed.

Please fully charge the battery when using a new battery or the battery used for the first time after long-term storage. Please ensure that it is charged and discharged at least every three months when the machine is not used for a long time.

Pipe Assembly & Disassembly

• Assembly: Select the end of the pipe without the button, align it with the Vacuum Cleaner and insert it directly, hear a click, then the assembly is in place.
• Disassembly: Simply press the pipe release button on the Vacuum Cleaner and pull the pipe outward.

Floor Brush Assembly & Disassembly

• Assembly : Select the end of the pipe with the button, align it with the floor brush and insert it directly, hear a click, the assembly is in place.
• Disassembly : Simply press the floor brush release button on the pipe and pull the pipe outward.

Charge

Method 1 : The Vacuum Cleaner can be charged directly on the Auto Empty Station, pay attention to the position of the charging pin (no need to remove the pipe and floor brush).

Using Vacuum Cleaner

• Start : Press the power button to start the Vacuum Cleaner, the vacuum works in AUTO gear by default.

• Suction Level : The Vacuum Cleaner has a total of 4 levels of suction power, 3 regular levels and 1 hidden powerful level. Short press “ ” on the end of the Vacuum Cleaner.

• Circularly adjustable level : ECO –Auto — High. Long press “ ” 2s will trigger Turbo power level, can be used to clean up larger particles.
  Note : The maximum duration of the Turbo power level is 10s.

• Power Off: In power on, press the power button again to power off.
  Note : The power button is a micro-action button that can be turned on/off with just a tap.

Using Auto Empty Station

• Charge :
  The Vacuum Cleaner can be charged directly on the Auto Empty Station, pay attention to the position of the charging pin (no need to remove the pipe and floor brush).

• Dust Collection:
  When the vacuum cleaner is placed on the Auto Empty Station, the dust bucket cover will automatically open. At this time, long press the function switch button “ ” for ls to activate the automatic dust collection function, and the dust collection time is 15s.

Note : Make sure the dust bag is installed before starting the dust collection

Maintenance

Vacuum Cleaner Maintenance

Body Maintenance: Wipe the surface of the machine with a damp cloth after wringing it out to prevent water from entering the device.

Dustbin and Filter Components Disassembly & Maintenance

Disassembly : Press the dustbin release button on both sides of the Vacuum Cleaner at the same time to disassemble the dustbin.

Note : After washing the HEPA filter and filter sponge, please air dry before use. (Do not expose to the sun).

Assemble

Filter Components Assembly

1. Install the filter element components according to the following figure.
2. Load the whole filter element assembly into the dustbin from the top, pay attention to the square mouth on the side of the filter element aligned with the suction socket of the dustbin;
3. Then place the sponge and HEPA filter on top of the filter element assembly. Note: Install the dustbin with the side of the HEPA filter with the rope facing up.

Install the dustbin

1. Put the dustbin clip into the Vacuum Cleaner clip, pay attention to be in place.
2. Push the bottom of the dustbin in the direction shown until you hear a click that snaps tightly.

Floor Brush Disassembly & Maintenance

Auto Empty Station Maintenance

Body Maintenance : Wipe the surface of the machine with a damp cloth after wringing it out to prevent water from entering the device.

Dust Bag Install & Disassembly

Note : The dust bag should be pushed to the bottom to avoid air leakage.

Troubleshooting

the battery correctly
Battery Dead| Charge the Vacuum Cleaner
Reduced Suction| Dust Cup Filter Blocked| Clean or replace the dust cup filter
Dust Cup Full of Dust| Use Auto Empty Base to clean dust in dust cup
The suction inlet pipe is blocked or the roller brush is blocked| Clean up the attached garbage in the suction head
Charging indicator does not light up when charging| The electrical terminal is not fully inserted into the DC terminal| Fully insert the charging terminal into the charging head
Short Endurance| ****

Insufficient Charging Time

| Fully charge the battery as instructed in the charging section
Battery Aging| The battery is a consumable item and can be replaced by contacting customer service during the warranty period

Roller brush does not run

| Poor contact between the floor brush and the pipe/ poor contact between the pipe and the Vacuum Cleaner| Restart the machine after ensuring firm contact

| The floor brush is blocked due to vacuum a large volume of foreign matters| Clean up floor brush tangles
The floor brush is blocked due to too much fiber wrapped by the roller brush
| Floor Brush Short Circuit| Please go to the designated service centre for replacement or send back for repair

| Fan Error| Check if the suction head is blocked and clear the blockage
If the Vacuum Cleaner is hot, turn off for a period of time before use
The air outlet is hot| Filter Components Blocked| Clear Dustbin and HEPA Filter
 | Auto Empty Station does not work| Power cord is loose| Please ensure that the power cord is installed in place
---|---|---|---
 | ****| The light is solid yellow indicates the dust bag is full| Replace New Dust Bag

Auto

| **| The light flashes in yellow indicates no dust bag installed/ dust bag not installed in place| Please install the dust bag correctly
Empty| /| /
Station| **| The light is solid red indicates the Auto Empty Station cover not installed in place| Please install the cover in place
 | | The light flashes in red slowly indicating the air duct is blocked| Clear the blockage of Auto Empty Station suction head and fan head
 | | The light flashes in red fast indicating the fan does not run| Please contact the Ultenic customer service team for processing at the following email address:

service-fr@ultenic.com

Specifications

Vacuum Cleaner Specifications

• Working Voltage: 29.6V
• Battery Capacity: 2500mAh
• Rated Power: 450W
• Adapter Rated Input: 100-240V~50/60Hz
• Adapter Rated Output: 34.2V=lA
• Charging Time: 2.5-3H
• Dustbin Capacity: 660ML

Auto Empty Base Specifications

• Input Voltage
  • EU Standard : 220-240V AC
  • US Standard: ll0-120VAC
• Rated Power: 1050W
• Dustbin Capacity: 3L

FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: {1) This device may not cause harmful interference, and {2) this device must accept any interference received, including interference that may cause undesired operation.

Warning : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour­aged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/ TV technician for help.

uk@ultenic.com)k@ultenic.com
Italia| service-it@uIten ic.com
B2J,:| service-jp@ultenic.com
Others| support@ultenic.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>