hermitlux HMX-DW04 Countertop Dishwasher User Manual
- June 14, 2024
- hermitlux
Table of Contents
hermitlux HMX-DW04 Countertop Dishwasher
Please read the manual carefully. It contains important imformation on how to install, use and maintain the machine. Please retain all documents for subsequent use or for next owner
IMPORTANT SAFETY INSTRUCTIONS
When using your dishwasher, follow basic precautions, including the following:
WARNING
- Read all instructions before using the dishwasher.
- Use the dishwasher only for its intended function.
- Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.
- When loading items to be washed:
- Locate sharp items so that they are not likely to damage the door seal;
- Load sharp knives with the handles up to reduce the risk of cut-type injuries.
- Do not wash plastic items unless they are marked” dishwasher safe” or the equivalent. For plastic items not so marked, check the manufacturer’s recommendations.
- Do not touch the heating element during or immediately after use.
- Do not tamper with controls.
- Do not abuse, sit on, or stand on the door or dish rack of the dishwasher.
- To reduce the risk of injury, do not allow children to play in or on a dishwasher.
- Under certain conditions, hydrogen gas may be produced in a hot-water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot-water system has not been used for such a period, before using the dishwasher turn on all hot-water faucets and let
- the water flow from each for several minutes. This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time.
- Remove the door to the washing compartment when removing an old dishwasher from service or discarding it.
- DO NOT IMMERSE IN WATER.
- HOUSEHOLD AND INDOOR USE ONLY.
- It is forbidden to open the door while the appliance is working to avoid personal danger. Don’t open the door when washing avoiding to hot water flying out and causing any hurts.
Safety and warning
- Power socket must be grounded, avoiding possible electric leakage or shock
- Don’t share one socket with other appliances avoiding to fire
- Any new parts or power line will be changed by the service man after damages
- Dispose of the machine in an environmentally friendly manner under local regurlations
- Do not place the machine in the environment under 32° F, like outside the door in cold weather
- Please use salt and detergent which is special for the dishwasher
- Don’t place and use the machine on the platform which is not stable, wet, smoothWarning inflammable avoiding any damage;
- Don’t place and use the machine within 5.9″ far from the gas stove or heater
- Don’t place any heavy objects on the door when the door opening to avoid the machine turn over
- Don’t splash water into the machine avoiding electric shock or fire
- Don’t drink the left water in the machine
- Don’t let children operate the machine independently avoiding any dangerousness.
Precaution
- Don’t open the door when washing avoiding to hot water flying out and causing any hurts
- Don’t touch the block of the side air outlet
- Don’t tilt or move the machine when washing
- The knife or others with sharp points don’t face person to avoid any hurts when opening the door
- Pleae stop washing, power off, and close the tap when any faults
- Please check and clean the machine from time to time for the best washing effect
- Please fix the drain hose avoiding to the stained water outflow
- Don’t forcibly pull power cord, drain hose, or press cutlery tray avoiding any damage
- Don’t use a wet hand to operate the machine avoiding electric shock
- Children should be far from the chemical material such as salt, detergent avoiding to any hurt
Product Introduction
Control Panel
Installation
- GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance to electric current. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. WARNING – Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt about whether the appliance is properly grounded. Do not modify the plug provided with the appliance, if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
lnlet hose installation
Connect machine
Insert the inlet hose elbow into the water inlet behind the machine and tighten the screw.
Connect tap
A, B, C are three options for tap connection, but B and C options need to make a hole on or behind cabinet for the hose can go through the cabinet. Note: The product has the characteristic of heating liquid; Water temperature does not be over 104 ° F if use hot water; The size of the inlet hose elbow is 1/2′ with internal thread, the tap size must be 1 /2′ with outer thread.
- Drain hose installation
Connect machine
Insert the drain hose elbow into the water outlet behind the machine and tighten the collar.
Connect sewer A, B, Care three options for sewer connection, B and C options need to make a hole on or under cabinet in order for the pipe can go through the cabinet. Note: A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is recommended that the hose be disconnected and the hole plugged.
Tableware Display
Please get rid of large food residue on tableware, avoiding blocking water
hose.
Please make reference to the right picture for tableware display. Note: In
order to fully clean tableware, please tilt tableware internally or put
stained face down; The capacity of the maximum number of place settings is
six.
- Operation
Power on Plug in, touch turn on the machine Note: Before the program
finishing, holdfor 3 seconds to force the machine to turn off.
Add detergent Open the door, add moderate detergent powder, or 1 pc
detergent block into the machine, and close the door. Note: No detergent
when fruit washing; The dosage: 8-109 each washing circle.
Program selection Touch , each of the program indicators will light one by
one, select the program you want.
-
Run program
Touch, run the selected program, the machine will check water supply automatically. Note: -
The system will automatically check all supplies are appropriate, if the indicators” f ” become red, you need open the tap or fill the tank;
-
After 5 times checking, there is still no water supply, the machine will enter standby mode;
-
Touch ” to force pause machine and add tableware during washing;
-
Touch for 3 seconds to quit the program, and the machine will drain, then stop; ®Touch “Dry” to add 73 hours’ circular wind to keep air fresh inside machine.
Wash
The machine has two water supply models, tap model and tank model. Note,
- The indicat is white, which means tank model;
- The indicatoris white, which means tap model;
- If tank is full, the machine will switch into tank model automatically;
- Fill 3 cups (1.8L water pitcher) of water into tank, Di, Di, Di will be sound if the tank is full, the indicator “o-9 ” will become white;
- If the tap model, please open the water tap.
Functions
Maintain & Clean
Clean Filter 0Disassemble
Rotate anti-clockwise to disassemble the filter set, which have 3 parts,
filter mesh, main filter and fine filter.
Clean
Use water to flush and brush each of the filter parts.
Assemble
After cleaning, rotated clockwise to close the filter set.
- Clean spray arms
Disassemble
Open the door, take out the basket, then pull out the up and down spray
arms.
Clean
Use water to flush and brush each spray arm, use tools with sharp point,
like needle to clean holes if needed.
Assemble
After cleanning, please press each arms into position, make sure the arms
can move smoothly.
Fault & problem
Fault codes
Code | Fault | How to deal with |
---|
“E2”
|
Draining
| 1.Check the drain pipe, be sure the pipe is straight, with no bending; 2.Power off, and check if anything blocks the filter or drain pipe; 3.Be sure all pipes are not blocked by something.
“E3”
|
Overflowing
| Tilt the machine to 30-45 degrees, and let water flow out from the base of
machine, restart the machine, if still show fault, contact our serviceman.
“E4”| Temperature|
Restart the machine, if still show fault, please contact our serviceman.
“E5”| Message
“E6”| Heating
“ET’| Pressure
problem1
Problem | Reason | How to deal with |
---|
Tableware is not clean
| Incorrect tableware loading| Be sure enough gap between tableware
Spray arm trapped| Be sure nothing traps the spray arm
Blocked spray arm| Clean spray arm
Blocked filter| Clean filter set
Incorrect filter installation| Correctly assemble the filter set
Incorrect program selection| Select appropriate washing program
No detergent| Add detergent (block/powder/liquid)
Don’t start the machine
| Water shortage| Add water till the indicator light off
Door does not close fully| Check the door if anything stops closing fully
Can not select program|
Be washing
| Re-select the program after stopping the in-progress program or wait in- progress program finishing
problem2
Faults | Reason | How to deal with |
---|
Tableware is wet
| Inappropriate program| Select appropriate program
Poor dry effect for plastic tableware| Wipe to dry by hand
Incorrect tableware setting| Correct tableware setting in accordance
Drying program not finish| Wait for dry program finishing
Wooden tableware| Wipe to dry by hand
Discoloration of plastic tableware| Over high washing
temperature
| Select the program with a lower temperature
Detergent left
| Blocked spray arm, no water flush detergent| Be sure the spray arm moves
smoothly
Detergent with poor quality|
Use qualified detergent
problem3
Faults | Reason | How to deal with |
---|
A mount of foam in the machine
|
Use incorrect detergent
| 1.Use special detergent for the dishwasher;
2.0 pen the machine, and wipe out the foam by hand;
3.Fill 2-3L water into the machine, and select any program, after 1-2min, the foam will be drained, repeat the process if needed.
Abnormal sound in the machine
| Spray arm knock
tableware
| Correctly set the tableware
Tableware move slightly| Fix tableware before washing
Egg custard left on the tableware|
Portein solidification
|
Clean the tableware with egg custard by hand
Water drops left inside of machine
|
Drying time is not enough
|
Select “Dry” program
Specification
Machine
Model No.: | HMX-DW04 |
---|---|
Voltage | 120V- |
Hz | 60Hz |
Power | 950W |
Inlet pressure | 0.03-lMPa |
Water consumption | 5L |
Place setting | 4sets |
Net weight | 26.461bs |
Machine size ( WXDXH ) | 16.85×16.73×18.03(in) |
Carton size (WXDXH) | 18.90×20.08×20.67(in) |
Dry | Hot wind |
Electrical Drawing
ROHS Requirement
Hazardous substances content
| substances
Components| ****
Pb
| ****
Hg
| ****
Cd
| ****
Cr6+
| ****
PBB
| ****
PBDE
Plasti parts| 0| 0| 0| 0| 0| 0
Metal parts| 0| 0| 0| 0| 0| 0
Rubber parts| 0| 0| 0| 0| 0| 0
Screws| 0| 0| 0| 0| 0| 0
Stickers| 0| 0| 0| 0| 0| 0
Heat plate| 0| 0| 0| 0| 0| 0
Wire| 0| 0| 0| 0| 0| 0
Water pumps| 0| 0| 0| 0| 0| 0
PCB, Fan| X| 0| 0| 0| 0| 0
Water valve| 0| 0| 0| 0| 0| 0
Parts of others| 0| 0| 0| 0| 0| X
The table is made according to SJ/T11364 standards.
0: indicates the hazardous substance contain is below the limit of GB/T265 72 standards.
X: indicate the hazardous substance contain is over the limitation of GB/T26572 standards, but fit for the RoHS order.
The information in the table is offered by suppliers, under the present skills, we will keep the best level of the hazardous substances in all of the machine parts and try our best to lower the level of the hazardous substances in the machine through improving the technologies constantly.
ZHIYUAN APPLIANCES CO.,LIMITED
3/F WORKINGTON TOWER 78 BONHAMSTRAND SHEUNG WAN HK Email:
info@hermitlux.com
Website :www.hermitlux.us
NOTE.
For easier reference,pleasent Original Sales Invoice or Official Receipt when
claiming warranty. The Manufacturer and/or Exclusive Distributor has the sole
discretion in determining the cause of defects.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>