Chungear TRD020Y2M Ceiling Fan Remote Controller User Guide

: June 14, 2024
: Chungear

Table of Contents

TRD020Y2M Ceiling Fan Remote Controller
Remarks:
To assure continued FCC compliance:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TRD020Y2M
TRD020Y2M Transmitter
operation instructions

TRD020Y2M Ceiling Fan Remote Controller

Transmitter specifications
1.5V AAA*2PCS
Transmission frequency: 304.25MHz

When the fan is turned off, press the button , the fan speed will be forced to increase by 3 speeds. Then began to pick up speed until 6 speed (LED Light signal in the rightmost)
When the fan is turned off, press the button , the fan speed will be forced to increase by 3 speeds. Then began to reduce speed until 1 speed (LED Light signal in the leftmost)
When the fan is turned off, only the emission indicator light will be on, the other light signals will not be displayed.
The setting of forward and reverse rotation needs to base on the ceiling fan is power on
Timer: (1H-2H-3H-4H-6H-8H)
From left to right, 1H: leftmost will be light up, 2H: the second one…6H: will be the fifth one and 8H: lights up in the rightmost. When press “0H”, except for the emission indicator light, the other indicator lights are not on.
If only press the comfort breeze button, only the emission indicator light will be on, the other indicator lights are not displayed.
Light key: Short press ON/OFF, Long press (more than1s) to continue dimming When operating the light button, only the emission indicator light is on, the other light signals are not displayed.
Turned on the power of receiver first, long press this button of the transmitter within 30 seconds. They can learn pairing immediately and can control the receiver.

Remarks:

When the FAN OFF key is pressed, the timing function will also be cleared.
When press the key of timing and it can hold for 1Min, then press the timing key and it can hold for 1min again. Reset the timer from 1 hour, Press once for 1h, press twice for 2h , and cycle in sequence.

To assure continued FCC compliance:

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
FCC ID：KUJCE11201
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.