MechaTronix CoolBay Tera-A Luminus Advanced High Bay LED Cooler Instruction Manual
- June 4, 2024
- MechaTronix
Table of Contents
MechaTronix CoolBay Tera-A Luminus Advanced High Bay LED Cooler
Mounting Options
The CoolBay® Tera-A comes with mounting patterns for the broadly used 28x28mm COB and 38x38mm COB sizes, as well as with the Zhaga Book 3 mounting holes to accomodate a wide range of LED holders for various brands. The wetting (contact between the LED engine and the LED cooler) is lifespan for these high power leds, so we suggest you to measure besides the Tc point also a place on the LED cooler near the contact area – when a temperature difference is observed than 10°C between these 2 points there is a potential contact issue.
Mounting indicator marks overview
MechaTronix recommends the use of a high thermal conductive interface between the LED module and the LED cooler. Either thermal grease, a thermal pad or a phase change thermal pad thickness 0.1-0.15mm is recommended. Thermal pads or phase change thermal pads can be preapplied from MechaTronix.
Luminus Gen 4 COB Array
- Model names
- CXM-32
- Mounting
- Direct mounting with 2 screws M3 x 4mm Red indicator marks
- With LED holder BJB spotlight connector 47.319.4160 Mounting with 4 screws M3 x 6mm Blue indicator marks
Luminus Gen 3 COB Array
- Model names
- CXM-32 (AC)
- Mounting
- Direct mounting with 2 screws M3 x 4mm Red indicator marks
- With LED holder BJB spotlight connector 47.319.4160 Mounting with 4 screws M3 x 6mm Blue indicator marks
Luminus Studio COB Gen 4
- Model names
- CVM-32
- Mounting
- Direct mounting with 2 screws M3 x 4mm Red indicator marks
- With LED holder BJB spotlight connector 47.319.4160 Mounting with 4 screws M3 x 6mm Blue indicator marks
No.818, Dashun 2nd Rd., Sanmin Dist., Kaohsiung City 80787, Taiwan
- [email protected]
- www.led-heatsink.com
- www.mechatronix-asia.com
- Tel: +886-7-381-5892
- Fax: +886-7-383-9293
- VAT: 28600841