KuWFi CPE850Q Dual Gigabit Port Wireless Bridge Installation Guide
- June 14, 2024
- KuWFi
Table of Contents
- CPE850Q Dual Gigabit Port Wireless Bridge
- Get Started to Know Your Wireless Bridge
- CPE Bridge Transmission Introduction
- Outdoor CPE Function
- Outdoor CPE Specification
- Wireless Bridge Set Up
- Bridge Configuration (WEB UI)
- Field Applications
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Outdoor CPE .
Quick Installation Guide .
CPE850Q Dual Gigabit Port Wireless Bridge
The dimensions are universal
20 degrees below zero
Get Started to Know Your Wireless Bridge
CPE Bridge Transmission Introduction
CPE850Q is a Dual Gigabit Qualcomm Chipset industrial 5G outdoor CPE with 6KM PTP/PTMP range. combined 900Mbps high speed in 5.8G, equipped Gigabit WAN port, 3 times Ethernet data rate faster than 300Mbps model, perfect for outdoor applications such as security cameras or wireless access points.
Outdoor CPE Function
- Long-distance 5.8G wireless transmission equipment
- Support point-to-point, point-to-multipoint mode
- Transmission distance up to 6km(Barrier-Free)
- AP+Repeater networking mode, video network dual compatible.
Outdoor CPE Specification
Wired Interface: 10/100/1000Mbps
Power scheme: POE 48V
Network Standard: IEEE802.11ac
Operating temperature: -40℃ ~ 70℃
Wireless Bridge Set Up
- Press F to enter setting mode,press S to select H or C mode
- Set another bridge to “C” as slave bridge
- Press”Reset” button to paid them
- Pair successfully They should show the same channel
Bridge Configuration (WEB UI)
SSID: Wireless 5.8G-XXXXXX; Password: 66666666 ; (Slave’SSID disabled by
default)
If you need to modify the wifi SSID, please login to the management page of
the M device to change the settings.
Note: Before configuring the Bridge IP, AP Configuration, Client
Configuration, make sure that the PC and CPE are properly connected and that
the PC IP is configured.
6.1 How to Configure Your PC IP As 192.168.188.xxx
a. Find the network icon in the lower right corner and click Open Network and
Internet Settings.
b. Select Ethernet and Click the Change Adapter Option.
C. Find the network connection you are using and right click on Properties.
d. Double- click the IPV4 setting, select the IP address below, enter the IP
and confirm.
e. Configure your PC IP as 192.168.188. xxx (xxx is a figure 2-250), note that
the set PC IP cannot be the same as the IP of the CPE.6.2 Login WebUI: 192.168.188.253; Default password: admin
Paired successfully before leaving the factory; Master=AP mode, Slave=Repeater
mode.
If reset it accidentally, Can log in the WEDU of M/S to setup AP/Repeater
respectively
Field Applications
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>