Kreafunk Portable Lamp with Dimmable Light 85x85mm User Manual
- June 14, 2024
- KREAFUNK
Table of Contents
Beam
Portable lamp with dimmable light
Operation manual
This product is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU. The declaration of conformity may
be consulted at:
https://Kreafunk.com/pages/declaration-of-conformity
The ABS plastic in this stylish product is made from 100% recycled plastic.
Overview
- USB-C
- 5V/1A
Charging
Charge your product to 100% before using it the first time.
- USB-C
- 5V/1A
Battery status
- 1 x flash each minute 0-10 %
- Red 0-10 %
10-100 %
On/off
Change light mode
- Change light mode
Dimming
Technical specifications
- 100% recycled GRS plastic
- Water-resistant (IPX4)
- Dimensions: 82x96mm (ØxH)
- Weight: 150g
- Operating time: up to 30 hours
- Charging time: 1-2 hours
- Dimmable light
- Touch sensor
- Rotatable in base
- Built-in Lithium battery with 3.7V, 600mAh
- USB-C cable included
- Input power: DC 5V / 1A
Safety and maintenance instructions
- Please read this operation manual carefully before use.
- The safety and maintenance instructions in this operation manual should be retained for future reference and must be followed at all times.
- Keep the product away from heat sources such as radiators, heaters or other appliances that produce heat.
- Place Beam in a stable position to avoid fall and cause damage or personal injury.
- Do not expose the product to direct sunlight for longer periods. High temperatures may shorten the life of the product, destroy the battery and distort certain plastic parts.
- Do not expose the product to extreme cold as it may damage the internal circuit board.
- Rechargeable batteries have a limited number of charge cycles. Battery life and number of charge cycles varies by use and settings.
- Avoid liquids getting into the product.
- Before wiping with a dry cloth to clean Beam, set the power switch to the off position and unplug the power cord from the power outlet.
- Do not throw with or stamp on the product. This may damage the internal circuit board.
- Do not try to disassemble the product. This must only be done by a professional.
- Do not use concentrated chemical products or detergent to clean the product.
- Keep the surface away from sharp things, as these may cause damage to the plastic parts.
- Use 5V / 1A power supplies only. The connection of power supplies with higher voltage may lead to severe damage.
- Do not arbitrarily discard or place the lithium battery near fire or intense heat in order to avoid a risk of explosion.
If you do experience any problems with your product please contact the retailer you purchased the product from. The retailer will provide you with guidance and if that does not solve the problem, the retailer will handle the claim directly with Kreafunk.
Kreafunk ApS
Klamsagervej 35A, st.
8230 Aabyhoej
Denmark
www.Kreafunk.com
info@Kreafunk.dk
+45 96 99 00 20
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>