BURNHARD 945099 Gas Bottles Adapter Jones Instruction Manual

BURNHARD 945099 Gas Bottles Adapter Jones

Product information

Specifications

• Dimensions: Approx. 220x60x50mm
• Weight: Approx. 750g (including hose and pressure reducer)
• Pants Length: 90 cm
• Pressure reducer: 1.5 bar
• Type of Gas: Butane (G30) and Propane (G31)
• Appliance Category: Direct Pressure

Product Usage Instructions

Connecting the gas system

CAUTION : The gas cylinder adapter is only tested and approved in conjunction with the JONES gas barbecue. Any structural modification or manipulation of the adapter is not permitted.

1. When using the gas cylinder adapter, always follow the instructions for use in the instruction manual for your foldable gas grill JONES.

Safety Instructions

Fire and explosion hazards. Please follow the general safety instructions:

• Never connect new or not completely empty gas cylinders if there are sources of ignition in the immediate vicinity. Don’t smoke.

Content Delivered

1. base
2. 2x quick-release adapters
3. Gas pants
4. Pressure reducer 1.5 bar

Leak test

Repeat the leak test after every gas cylinder change.

Assembly instructions

1. Screw both Quick Release Adapters into the existing JONES regulators. Make sure the regulators are closed.

Use

1. Refer to the instruction manual for proper usage.
2. The angle of the gas hose is designed to fit the JONES grill.

Cleaning and Care

1. Wipe all parts with a cloth.
2. Dry all parts before reassembling.

Customer Service

Email: service@burnhard.de
Website : www.burnhard.de

Disposal/recycling

Properly dispose of the product following environmental regulations.

FAQ (Frequently Asked Questions)

• Q: Can I use the gas cylinder adapter with any gas grill?
  A: No, the gas cylinder adapter is only tested and approved for use with the JONES gas barbecue. Do not use it with other grills.

• Q: How often should I perform the leak test?
  A: It is recommended to perform the leak test after every gas cylinder change to ensure safety.

• Q: Can I connect a new or partially filled gas cylinder?
  A: No, do not connect new or not completely empty gas cylinders if there are sources of ignition nearby. This can be a fire and explosion hazard.

TECHNICAL DATA

• Dimensions: approx. 200 x 60 x 50 mm
• Weight: approx. 750 g incl. gas hose and pressure reducer
• Hose length: 90 cm
• Pressure reducer: 1.5 bar
• Type of gas: Butane (G30) and propane (G31)
• Appliance category: Direct pressure

Subject to changes and errors in features, technology, colors, and design.

EXPLANATION OF SYMBOLS
This symbol warns of hazards that may cause damage to the unit or result in injury.

CONNECTING THE GAS SYSTEM

CAUTION : The gas cylinder adapter is only tested and approved in conjunction with the JONES gas barbecue. Any structural modification or manipulation of the adapter is not permitted.
When using the gas cylinder adapter, please always follow the instructions for use in the instruction manual for your foldable gas grill JONES.

SAFETY INSTRUCTIONS

Fire and explosion hazard

GENERAL SAFETY INSTRUCTIONS

• This gas barbecue may only be operated with a pressure reducer. The enclosed 1.5 bar pressure reducer is correctly set at the factory for operation with liquid gas.
• Only use outdoors. Gas barbecues and gas cylinder adapters must never be used in enclosed spaces, garages, summerhouses, etc. (There is an acute fire risk).
• The gas hose may need to be replaced if there are corresponding national requirements.
• Make sure that there is no source of ignition, naked flame, or similar in the vicinity when replacing the gas cylinder.
• Seek advice from a specialist dealer when buying or renting a gas cylinder.
• Connect the device as described in this manual. Make sure that the gas hose is not kinked or chafed.
• Carry out the leak test procedure described in this instruction manual (found under CONNECTING THE GAS CYLINDER) before using the barbecue. Always carry out a leak test.
• Keep the gas cylinder out of reach of children.
• Keep the gas cylinder away from oxidizing gases and other oxidizing substances.
• Escaping liquid gas is heavier than air and sinks to the ground. Do not store the gas cylinder indoors, below ground level (e.g. in the cellar, underground car park, etc.), or in unventilated places where escaping gas could collect.
• Protect the gas cylinder from direct sunlight and other sources of heat. Store the gas cylinder at less than 50 °C in a well-ventilated, shady place that is protected from the weather.
• Store the gas cylinder upright and secure it against falling over.
• Do not store spare/additional or unconnected gas cylinders under or near the gas barbecue.
• The storage instructions also apply to empty gas cylinders.  These still contain a residual amount of liquid gas.
• When the appliance is not in operation, the cylinder must be disconnected. Replace the protective cap on the cylinder after it has been disconnected from the appliance.

CONTENTS DELIVERED

No. Description

1. Base
2. 2x quick-release-adapters
3. Gas hose
4. Pressure reducer 1.5 bar

CONNECTING THE GAS CYLINDER

Fire and explosion hazard

CAUTION : Never connect new or not completely empty gas cylinders if there are sources of ignition in the immediate vicinity. Do not smoke.
The following parts are included in the scope of delivery. They comply with the standard applicable to the respective country to which the barbecue is delivered

• Gas hose (pre-assembled): CE-approved hose line of sufficient length (max. 1.5 m) that allows kink-free assembly.
• Pressure reducer (pre-mounted on the gas hose): fixed and CE-approved pressure reducer according to DIN EN 16129, max. 80 kg/h, operating pressure 1.5 bar suitable for the gas cylinder used.

1. Place the gas cylinder securely on the floor or on a flat surface] to prevent it from falling over.
2. Screw the union nut on the end of the hose onto the thread of the gas connection for the barbecue. Tighten it with a spanner

Danger of explosion due to damage to the gas hose
CAUTION : When routing the gas hose, ensure that the following requirements are met:

• The gas hose does not come into contact with hot surfaces.
• The gas hose does not run along sharp edges and corners.
• No hot grease or liquids can drip onto the gas hose.
• The gas hose is not twisted or kinked at any point.

LEAK TEST

• Spray all sealing points with commercial leak detection spray or brush them with soapy water (ratio: 1 part soap to 3 parts water).
• Turn on the valve for the gas cylinder. Small bubbles appear in leaking areas.
• Close the valve on the gas cylinder.
• Tighten the nuts on both connection sides again by hand and repeat the leak test. If bubbles still appear, close the  gas valve on the cylinder and consult a specialist dealer.

Repeat the test after each gas cylinder change.

WARNING : Check the gas connections for breaks, cracks or wear before each use. If you find any of these issues, do not use the adapter until the problem has been fixed.
When changing or unscrewing the gas cylinder, make sure that no fire sources, such as candles, electrical appliances or cigarettes, are within reach. Always check that the cylinder is properly turned off. Do not store the unscrewed gas cylinder near this or any other barbecue

ASSEMBLY INSTRUCTION

1. Screw both quick-release adapters into the existing JONES regulators.
   CAUTION : Make sure that the regulators are closed

2. Engage the two regulators into the base: the left from the left, the right from the right. To do this, the control knobs must point upwards to slide into the slots as intended

3. Mount the base into the same groove on both burners.
   ATTENTION : It is essential to make sure that the base is  only hung in the front groove!

4. Click one end of the gas hose onto the gas adapter and screw the other end onto the pressure reducer. Then screw the pressure reducer onto the gas bottle.

USE

1. Turn on the gas cylinder valve.
2. Then use your JONES barbecue according to the instruction manual.
3. The elbow on the gas hose serves to ensure that the JONES barbecue can be used safely on the table or on the floor. You can turn the elbow freely and align it in the direction of the gas cylinder. Please note that the gas hose must not pass under the barbecue and must not touch the barbecue. The elbow may be angled forward, to the right, to the left and in any position in between, but not facing the barbecue.

SWITCHING OFF THE BARBECUE

1. Turn all dials to the off position.
2. Close the valve on the gas cylinder.

DISMANTLING

1. Remove the gas hose by pressing the lower quick-release button. To do this, pull the upper ring (on the gas hose fitting) back a little so that the adapters pop out.
2. Remove the elbow that is at the end of the hose.
3. Pull the adapter upwards off the burners.
4. Operate the right and left quick-release one after the other and remove the gas regulators.
5. Unscrew the click adapter from both gas regulators.

CLEANING AND CARE

The gas adapter should be cleaned and dried after each use. Lack of or improper care of the appliance may impair its functionality. The gas adapter should only be cleaned when it is no longer connected to the gas bottle via the gas hose.

1. Never clean the gas adapter directly under water or any other liquid!
2. Do not use any abrasive or scratching cleaning agents.
3. The gas adapter is not suitable for dishwasher cleaning!
4. Wipe the housing of the adapter with a damp cloth.
5. Dry all parts well with a soft cloth before reassembling.

Before using the gas adapter again, all parts should be  thoroughly cleaned and dry

CUSTOMER SERVICE

Our products have a legal warranty duty of 2 years. Further claims can only be processed in conjunction with proof of purchase. Wearing parts excludes any warranty claims when usual abrasion has occurred. The durability is determined by the respective handling and use of the products and is thus variable. For questions concerning the handling and functionality of our  products, please contact our customer service:

• Free hotline for Germany/Austria only: 0800 270 70 27
• From other EU countries: +49 211 – 749 55 10*
• Different costs may apply.
• E-Mail : service@burnhard.de
• Internet : www.burnhard.de

DISPOSAL/RECYCLING

Our products are manufactured to high-quality standards and are designed for a long service life.
Regular maintenance and care will help to extend service life. If the appliance is defective and can no longer be repaired, it must not be disposed of in the normal household waste.
The product and packaging must be disposed of in accordance with local regulations. If necessary, contact your local waste disposal company for more information.

DECLARATION OF CONFORMITY

Springlane GmbH hereby declares that this product conforms to the basic CE requirements as of the day of publication. The full declaration of conformity can be found at www.burnhard.de.

IMPRESSUM
Aufbau- und Bedienungsanleitung
Gasflaschen Adapter für Klappgrill JONES
Art-Nr.: 945099
Druck- und Satzfehler vorbehalten.
Stand: Mai 2023
Copyright © BURNHARD Eine Marke der Springlane GmbH Reisholzer Werftstraße 25a 40589 Düsseldorf, Germany
Telefon : +49 (0)211 749 55 10
Telefax : +49 (0)211 749 55 11 0
E-Mail: info@burnhard.de
www.burnhard.de

SERVICE-HOTLINE

Free hotline for Germany/Austria: 0800 270 70 27
From other EU countries: +49 211 – 749 55 10*
Different costs may apply.
E-Mail: service@burnhard.de

References

• Grills und Grillzubehör von Grillern für Griller | Burnhard

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>