LB-LINK BL-AC3600 LTE Router Installation Guide

June 9, 2024
LB-LINK

Installation Guide

Version:V1.0
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Step 1 Hardware Connections

  • This picture is for reference only, the specific interfaces and buttons are subject to the actual objectLB LINK BL AC3600 LTE Router

Step 2 Internet settings

Connect the phone (or computer) to the router’s “wireless-XXXX” and then set it up as following steps:
(XXXX represents the last 4 digits of the MAC address, or see the sticker on the back of the router to obtain the wireless network name)LB LINK BL AC3600
LTE Router - fig

Led lights function description

System light (single light and two-colors)

Red light steady on| Powered on
Red light off| System is starting
Red light flashes| Without network
Blue or green light is steady on| Network connected

Network Led light

Light steady on or flashes| Network cable connected
Light off| Network cable not connected

Panel light status (multiple lights)

Power light| Steady on: powered on
WiFi light| Light off: the system is starting
Light flashing: data transmission is available (it is always on when there is no data)
WAN/LAN light| Light on: Network cable is connectedLight off: Network cable is not connected
Light flashing: data transmission is available
Note: 5G WiFi is steady on for some models

Interfaces/buttons description

Interface

POWER| Power port
WAN (Network input port)| Can be connected to optical modem or community broadband connectio
LAN (Network output port)| Can be connected to computers, set-top boxes and other wired devices
Double reset button

WPS (key)| Press for 2-3 seconds to trigger WPS
RESET (small hole)| Press and hold for 10-15 seconds to restore factory settings
Single reset button

WPS/RST button| Short press 1 to 2 seconds for WPS connection, long press 10 to 15 to restore factory Settings
Note: “WPS/RST” are small holes for some models

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals