MOUNTUP MU4001 Single Laptop Tray Desk Mount Instruction Manual
- June 14, 2024
- MOUNTUP
Table of Contents
Laptop Tray Desk Mount
Instruction Manual
If you have any questions, please contact us.
WARNING!
If you do not understand these instructions or have doubts about the safety
of the installation, assembly or use of this product,please contact us.
Before starting assembly, verify all parts are included and undamaged.
Improper installation may cause damage or serious injury. Do not use this
product for any purpose that is not explicitly specified in this manual. Do
not exceed weight capacity. We cannot be liable for damage or injury caused by
improper mounting, incorrect assembly or inappropriate use.
This product contains small items that could be a choking hazard if swallowed.
NOT FOR CHILDREN UNDER 3 YEARS.
ADULT SUPERVISION IS REQUIRED.
PACKAGE CONTENTS
NOTE: Not all hardware included will be used.
DO NOT EXCEED WEIGHT CAPACITY.
ASSEMBLY STEPS
STEP 1: Clamp Installation OR Grommet Base Installation
OPTION A: Clamp Installation
Install the Clamp (C) to the Pole (D) using 3pcs Bolt (G). Tighten using 4mm
Allen key (K).
Secure stand to the desktop by tightening the plastic knob or by using 6mm
Allen key (L). OPTION B: Grommet Base Installation
If existing grommet hole comes with a plastic protector, remove it to ensure a
fiat surface before installing the desk mount.
Loosen the screw, separate the clamp (C) into two parts. Install the Base
Plate (F) to the Pole(D )using 1pc of Bolt (G).
Install the pole (D) on the desktop using the support plate (H) and the bolt
separated from clamp(C).
Secure stand to desktop by tightening the plastic knob or by using 6mm Allen
key (L). STEP 2 : Arm Installation
Install wire clip (E) and swivel arms (B) to the pole (D). Fasten the bolt
with supplied 6mm Allen key (L).
Attached the wire clips (I) to the swivel arm (B). STEP 3 : Attach the VESA
Plate to the Laptop Tray
Install the VESA plate (A) to the laptop tray (M) using 4pcs screws (O) and
4pcs nuts (P) , tighten by 6mm Allen key (L) . Apply pads (N) to the laptop
tray to avoid laptop scratches. STEP 4: Hang Laptop Tray
Slide the laptop tray onto the head of swivel arm (B). Install the security
bolt (J).
Make sure the security bolt is installed before you rotate the laptop tray.
STEP 5 : Secure the Laptop on the Laptop tray
STEP 6: Tilt Adjustment
Tighten the bolt with the supplied 6mm Allen key (L) to fix the tilt angle.
Guideline to adjust monitor tilting angle.
Note:
- Loosen the tilting bolt.
- Adjust monitor to your desired tilting angle.
- Retighten the tilting bolt to fix the tilting angle.
STEP 7: Cable Management
Manage cables and store Allen keys (K,L) in wire clip (E) for future use.
Adjust as Desired
Adjust monitor position and rotation.
Pay attention while clamp install!
Product Dimensions
CAUTION AND MAINTENANCE:
- Never allow children to climb, stand, hang, or play on any part of monitor or stand.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
- Check that the bracket is secure and safe to use at regular intervals (at least every three months).
If you have any questions, please contact us.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>