kreafunk Bell Alarm Clock with Turning Sensor Instruction Manual
- June 14, 2024
- KREAFUNK
Table of Contents
Bell
Alarm clock with turning sensor
Operation manual
Bell Alarm Clock with Turning Sensor
This product is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU.
The declaration of conformity may be consulted at: https://Kreafunk.com/pages
/declaration-of-conformity
The ABS plastic in this stylish product is made from 100% recycled plastic.
Overview
Charging
Charge your product to 100% before using it the first time.
Battery status
On/off
Switch time mode (12/24h)
Set time
Set alarm
Snooze
Alarm off
When alarm is ringing
Alarm on/off
When alarm is not ringing Alarm will not start again the day after if you turn off alarm
Display brightness
*The display will turn off after 4
minutes and activate again when touching Bell or pressing K button.
Reset
Technical specifications
- 100% recycled GRS plastic
- Water-resistant (IPX4)
- Dimensions: 102x115mm (ØxH)
- Weight: 165g
- Operating time: up to 30 days
- Charging time: 1-2 hours
- Alarm clock
- Snooze by using flip sensor
- Dimmable LED display
- Rotatable in base
- Built-in Lithium battery with 3.7V, 600mAh
- USB-C cable included
- Input power: DC 5V / 1A
Safety and maintenance instructions
- Please read this operation manual carefully before use.
- The safety and maintenance instructions in this operation manual should be retained for future reference and must be followed at all times.
- Keep the product away from heat sources such as radiators, heaters or other appliances that produce heat.
- Place Bell in a stable position to avoid fall and cause damage or personal injury.
- Do not expose the product to direct sunlight for longer periods. High temperatures may shorten the life of the product, destroy the battery and distort certain plastic parts.
- Do not expose the product to extreme cold as it may damage the internal circuit board.
- Rechargeable batteries have a limited number of charge cycles. Battery life and number of charge cycles varies by use and settings.
- Avoid liquids getting into the product.
- Before wiping with a dry cloth to clean Bell, set the power switch to the off position and unplug the power cord from the power outlet.
- Do not throw with or stamp on the product. This may damage the internal circuit board.
- Do not try to disassemble the product. This must only be done by a professional.
- Do not use concentrated chemical products or detergent to clean the product.
- Keep the surface away from sharp things, as these may cause damage to the plastic parts.
- Use 5V / 1A power supplies only. The connection of power supplies with higher voltage may lead to severe damage.
- Do not arbitrarily discard or place the lithium battery near fire or intense heat in order to avoid a risk of explosion.
If you do experience any problems with your product please contact the retailer you purchased the product from. The retailer will provide you with guidance and if that does not solve the problem, the retailer will handle the claim directly with Kreafunk.
www.fsc.ong
MIX
The mark of responsible forestry
FSC® A000519
Kreafunk ApS
Klamsagervej 35A, st.
8230 Aabyhoej
Denmark
www.Kreafunk.com
info@Kreafunk.dk
+45 96 99 00 20
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>