kreafunk Ellie Lamp with Wireless Charger Instruction Manual

: June 14, 2024
: KREAFUNK

Table of Contents

kreafunk Ellie Lamp with Wireless Charger
Safety and maintenance instructions
Overview
Manual Bluetooth pairing
Technical specifications
FCC statement
Safety and maintenance instructions
Precautions and taking care of Ellie
CONTACT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

kreafunk Ellie Lamp with Wireless Charger

Safety and maintenance instructions

This product complies with the essential requirements and other relevant provisions of Directive 2014/53/EU.
The declaration of conformity may be consulted at: https://Kreafunk.com/pages/declaration-of-conformity This stylish product is made from 100% recycled plastic.

Overview

On/off

Charging

Change light mode

Dimming

Manual Bluetooth pairing

kreafunk-Ellie-Lamp-with-Wireless-Charger-FIG-6

Listen via Bluetooth

Play/pause

Phone

Technical specifications

100% recycled GRS plastic
Water-resistant (IPX4)
Dimensions: 120x120x320mm
Weight: 375g
Standard: Qi wireless charging
Compatible with Qi-enabled devices
Qi output power: 10W
Charging efficiency: ≥72%
Charging distance: ≤5 mm
Speaker: Ø45mm 4Ω 5W
Lamp: 3 light settings
Built-in microphone
Bluetooth: version 5.1
Range: up to 10m
Input power: DC 9V / 2A
Frequency band: 2402–2480 MHz
Maximal radio frequency effect: <3 dBm
USB-C cable included. Please note, that the power adapter is not included.
We suggest using a 20W adapter to get the most out of Ellie – especially when charging your phone.

FCC statement

This device complies with part 15 of the FCC rules. operation is subject to the following two conditions:

This device may not cause harmful interference and
This device must accept any interference received, including interference that may cause undesired operation.

Important: Changes or modifications to this product not authorized could void the FCC compliance and negate your authority to operate the product.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits a signed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Safety and maintenance instructions

Please read this operation manual carefully before use.
The safety and maintenance instructions in this operation manual should be retained for future reference and must be followed at all times.
Keep the product away from heat sources such as radiators, heaters or other appliances that produce heat.
Place Ellie in a stable position to avoid falling and cause damage or personal injury.
Do not expose the product to direct sunlight for longer periods. High temperatures may shorten the life of the product, destroy the battery and distort certain plastic parts.
Do not expose the product to extreme cold as it may damage the internal circuit board.
Rechargeable batteries have a limited number of charge cycles. Battery life and number of charge cycles vary by use and settings.
Avoid liquids getting into the product.
Before wiping with a dry cloth to clean Ellie, set the power switch to the off position and unplug the power cord from the power outlet.
Do not throw with or stamp on the product. This may damage the internal circuit board.
Do not try to disassemble the product. This must only be done by a professional.
Do not use concentrated chemical products or detergent to clean the product.
Keep the surface away from sharp things, as these may cause damage to the plastic parts.
Use 5V / 1A power supplies only. The connection of power supplies with higher voltage may lead to severe damage.
Do not arbitrarily discard or place the lithium battery near fire or intense heat to avoid a risk of explosion.

If you do experience any problems with your product please contact the retailer you purchased the product from. The retailer will provide you with guidance and if that does not solve the problem, the retailer will handle the claim directly with Kreafunk.

Precautions and taking care of Ellie

This product should be used and stored at a temperature between -20° to 40°, and humidity should be less than 85%.
Be sure not to place the product in a high-temperature environment during charging to avoid overheating and damage.
Keep this product in a dry place. Never place or use this product in wet or dirty conditions.
Never throw this product into a fire.
Never throw or drop this product as it may cause damage and malfunction.
Do not place anything between the mobile device being charged and the charging pad.
Never attempt to alter or disassemble this product. If there is a problem with the product, please contact your seller for further assistance.
Keep away from high voltage devices (highest 9V).
Do not place the product too close to magnetic stripe cards or chip cards (credit cards, ID cards, etc.) to avoid magnetic failure.
Please keep a distance at least 20 cm between the product and implantable medical devices (pacemakers, implantable cochlear, etc.) to avoid potential interference with the medical device.
If you need to clean the charger, please make sure it is not connected to the AC adaptor.
Don’t place heavy objects on the product. This may damage the internal circuit board.
This product is not a toy. Please keep away from children.
Respective countries have their laws on the minimum age allowed to operate chargers. Please check with your respective authority for further information.
All products have gone through a thorough quality assurance inspection. If you find that your device is excessively hot, is emitting an odour, is deformed, abraded, cut or is experiencing or demonstrating an abnormal phenomenon, immediately stop all product use and contact the Manufacturer.